lkml.org 
[lkml]   [2009]   [Oct]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: [PATCH] at91: at91sam9g20ek modify dual slot evaluation kit
    > +	  that embeds only one SD/MMC slot.
    > +
    > +config MACH_AT91SAM9G20EK_2MMC
    > + bool "Atmel AT91SAM9G20-EK Evaluation Kit with 2 SD/MMC Slots"
    > + depends on ARCH_AT91SAM9G20
    > + help
    > + Select this if you are using an Atmel AT91SAM9G20-EK Evaluation Kit
    > + with 2 SD/MMC Slots. This is the case for AT91SAM9G20-EK rev. C and
    > + onwards.
    >
    > config MACH_CPU9G20
    > bool "Eukrea CPU9G20 board"
    > @@ -392,7 +394,7 @@ config MTD_AT91_DATAFLASH_CARD
    >
    > config MTD_NAND_ATMEL_BUSWIDTH_16
    > bool "Enable 16-bit data bus interface to NAND flash"
    > - depends on (MACH_AT91SAM9260EK || MACH_AT91SAM9261EK || MACH_AT91SAM9G10EK || MACH_AT91SAM9263EK || MACH_AT91SAM9G20EK || MACH_AT91SAM9G45EKES || MACH_AT91CAP9ADK)
    > + depends on (MACH_AT91SAM9260EK || MACH_AT91SAM9261EK || MACH_AT91SAM9G10EK || MACH_AT91SAM9263EK || MACH_AT91SAM9G20EK || MACH_AT91SAM9G20EK_2MMC || MACH_AT91SAM9G45EKES || MACH_AT91CAP9ADK)
    it's time to replace this by select it at machine config state

    > @@ -254,7 +257,11 @@ static void __init ek_board_init(void)
    > /* Ethernet */
    > at91_add_device_eth(&ek_macb_data);
    > /* MMC */
    > +#if defined(CONFIG_MMC_ATMELMCI) || defined(CONFIG_MMC_ATMELMCI_MODULE)
    > at91_add_device_mci(0, &ek_mmc_data);
    > +#else
    > + at91_add_device_mmc(0, &ek_mmc_data);
    > +#endif
    do we really need to do this choice at board level?

    Best Regards,
    J.


    \
     
     \ /
      Last update: 2009-10-21 17:55    [W:0.024 / U:32.052 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site