lkml.org 
[lkml]   [2009]   [Jan]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Checking module parameters
On Mon, Jan 19, 2009 at 11:19:34AM +0100, Stefan Richter wrote:
> Nick Craig-Wood wrote:
> > David Wagner <daw@cs.berkeley.edu> wrote:
> >> Is there a way to tell what options have been applied to a currently
> >> loaded kernel module?
> >>
> >> I'm trying to force libata to use 1.5Gbps rather than 3Gbps,
> ...
> > I had to do this recently (under debian I ended up putting
> > "libata force=1.5Gbps" into /etc/modules)
> >
> > You can check it is working by looking for something like this in the log
> >
> > [ 2.345058] ata1: FORCE: PHY spd limit set to 1.5Gbps
> > [ 2.345058] ata1: SATA max UDMA/133 abar m2048@0xfb106000 port 0xfb106100 irq 218
>
> There is also /sys/module/*/parameters/* which can be read and in some
> cases even be written.

It doesn't appear to show the force parameter. From the same server
as above :-

$ more /sys/module/libata/parameters/* | cat
::::::::::::::
/sys/module/libata/parameters/acpi_gtf_filter
::::::::::::::
3
::::::::::::::
/sys/module/libata/parameters/allow_tpm
::::::::::::::
0
::::::::::::::
/sys/module/libata/parameters/ata_probe_timeout
::::::::::::::
7500
::::::::::::::
/sys/module/libata/parameters/atapi_dmadir
::::::::::::::
0
::::::::::::::
/sys/module/libata/parameters/atapi_enabled
::::::::::::::
1
::::::::::::::
/sys/module/libata/parameters/atapi_passthru16
::::::::::::::
1
::::::::::::::
/sys/module/libata/parameters/dma
::::::::::::::
7
::::::::::::::
/sys/module/libata/parameters/fua
::::::::::::::
0
::::::::::::::
/sys/module/libata/parameters/ignore_hpa
::::::::::::::
0
::::::::::::::
/sys/module/libata/parameters/noacpi
::::::::::::::
0

--
Nick Craig-Wood <nick@craig-wood.com> -- http://www.craig-wood.com/nick


\
 
 \ /
  Last update: 2009-01-19 13:51    [W:0.076 / U:0.452 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site