Messages in this thread | | | Date | Mon, 19 Jan 2009 13:23:40 +0100 | From | Thomas Dahlmann <> | Subject | Re: amd5536udc interrupts bug |
| |
>> Unfortunately this bit is not the complete solution for your problem. >> When setting PUE then connect and disconnect events cannot be >> detected by UDC. If you disconnect and connect again you >> probably will notice that there will be no new enumeration as >> expected. > > Interestingly enough, when running in this configuration, unplugging and > replugging the cable does cause a re-enumeration. Hmmmm. > > -- Vadim Lobanov >
Ah, I see. So PUE would be OK so far. I assume this worked as host recognizes a disconnect/connect and performs a USB reset. USB reset has almost the same effect as disconnect/connect on device side.
Thomas
| |