lkml.org 
[lkml]   [2008]   [Sep]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [RFC][PATCH] MMC: Use write timeout value as read from CSR
Date
On Monday 08 September 2008, Matt Fleming wrote:
> Currently, the MMC/SD over SPI code has a hard-coded timeout value of
> 250ms on writes and 100ms on reads. This is correct for SDHC cards
> and is specified in the spec, but it is not correct for MMC/SD cards.
>
> For MMC cards the values that are read from the CSR should be used.
> For SD cards the values from the CSR should be used as long as they
> do not exceed 250ms for writes and 100ms for reads.
>
> Signed-off-by: Matthew Fleming <matthew.fleming@imgtec.com>

OK by me. I was viewing those values as ceilings, such that
waiting too long wouldn't much matter. If there are cases
where the CSR values are larger, they clearly should trump.



\
 
 \ /
  Last update: 2008-09-08 21:27    [W:0.084 / U:5.848 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site