lkml.org 
[lkml]   [2008]   [Jul]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/7] [MTD] Blackfin NFC Driver: add support for the ECC layout the Blackfin bootrom uses
Date
From: Mike Frysinger <vapier.adi@gmail.com>

Signed-off-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
---
drivers/mtd/nand/Kconfig | 12 ++++++++++++
drivers/mtd/nand/bf5xx_nand.c | 40 ++++++++++++++++++++++++++++++++++++++++
2 files changed, 52 insertions(+), 0 deletions(-)

diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index 5076faf..6ca1ec0 100644
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -110,6 +110,18 @@ config MTD_NAND_BF5XX_HWECC
Enable the use of the BF5XX's internal ECC generator when
using NAND.

+config MTD_NAND_BF5XX_BOOTROM_ECC
+ bool "Use Blackfin BootROM ECC Layout"
+ default n
+ depends on MTD_NAND_BF5XX_HWECC
+ help
+ If you wish to modify NAND pages and allow the Blackfin on-chip
+ BootROM to boot from them, say Y here. This is only necessary
+ if you are booting U-Boot out of NAND and you wish to update
+ U-Boot from Linux' userspace. Otherwise, you should say N here.
+
+ If unsure, say N.
+
config MTD_NAND_RTC_FROM4
tristate "Renesas Flash ROM 4-slot interface board (FROM_BOARD4)"
depends on SH_SOLUTION_ENGINE
diff --git a/drivers/mtd/nand/bf5xx_nand.c b/drivers/mtd/nand/bf5xx_nand.c
index fc58afe..3555f6b 100644
--- a/drivers/mtd/nand/bf5xx_nand.c
+++ b/drivers/mtd/nand/bf5xx_nand.c
@@ -91,6 +91,41 @@ static const unsigned short bfin_nfc_pin_req[] =
P_NAND_ALE,
0};

+#ifdef CONFIG_MTD_NAND_BF5XX_BOOTROM_ECC
+static uint8_t bbt_pattern[] = { 0xff };
+
+static struct nand_bbt_descr bootrom_bbt = {
+ .options = 0,
+ .offs = 63,
+ .len = 1,
+ .pattern = bbt_pattern,
+};
+
+static struct nand_ecclayout bootrom_ecclayout = {
+ .eccbytes = 24,
+ .eccpos = {
+ 0x8 * 0, 0x8 * 0 + 1, 0x8 * 0 + 2,
+ 0x8 * 1, 0x8 * 1 + 1, 0x8 * 1 + 2,
+ 0x8 * 2, 0x8 * 2 + 1, 0x8 * 2 + 2,
+ 0x8 * 3, 0x8 * 3 + 1, 0x8 * 3 + 2,
+ 0x8 * 4, 0x8 * 4 + 1, 0x8 * 4 + 2,
+ 0x8 * 5, 0x8 * 5 + 1, 0x8 * 5 + 2,
+ 0x8 * 6, 0x8 * 6 + 1, 0x8 * 6 + 2,
+ 0x8 * 7, 0x8 * 7 + 1, 0x8 * 7 + 2
+ },
+ .oobfree = {
+ { 0x8 * 0 + 3, 5 },
+ { 0x8 * 1 + 3, 5 },
+ { 0x8 * 2 + 3, 5 },
+ { 0x8 * 3 + 3, 5 },
+ { 0x8 * 4 + 3, 5 },
+ { 0x8 * 5 + 3, 5 },
+ { 0x8 * 6 + 3, 5 },
+ { 0x8 * 7 + 3, 5 },
+ }
+};
+#endif
+
/*
* Data structures for bf5xx nand flash controller driver
*/
@@ -712,6 +747,11 @@ static int bf5xx_nand_probe(struct platform_device *pdev)

/* setup hardware ECC data struct */
if (hardware_ecc) {
+#ifdef CONFIG_MTD_NAND_BF5XX_BOOTROM_ECC
+ chip->badblock_pattern = &bootrom_bbt;
+ chip->ecc.layout = &bootrom_ecclayout;
+#endif
+
if (plat->page_size == NFC_PG_SIZE_256) {
chip->ecc.bytes = 3;
chip->ecc.size = 256;
--
1.5.6


\
 
 \ /
  Last update: 2008-07-27 08:31    [W:0.046 / U:1.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site