Messages in this thread |  | | | Date | Thu, 17 Jul 2008 22:44:20 -0600 | | From | Grant Likely <> | | Subject | Re: [PATCH] leds: implement OpenFirmare GPIO LED driver | |
On Fri, Jul 18, 2008 at 01:35:12PM +1000, David Gibson wrote:
> This brings us back to the issue we also have with DCR controlled
> devices. Possibly we should have two ways of representing these
> connections: for "pure" GPIO-only or DCR-only devices, they appear
> under the relevant controller with the addresses encoded with 'reg'.
> For devices on other busses which also have a few GPIO lines / DCR
> registers, they would appear on the other bus with 'gpios' or
> 'dcr-reg' properties (or some new, generalized 'other-bus-reg'
> property).
On the other hand; it's just LEDs. I think a single scheme is enough.
:-)
g.
|  |