Messages in this thread Patch in this message | | | From | Bartlomiej Zolnierkiewicz <> | Date | Wed, 28 May 2008 23:41:04 +0200 | Subject | [PATCH 09/21] ht6560b: convert to use ide_timing_find_mode() |
| |
There should be no functional changes caused by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com> --- drivers/ide/Kconfig | 1 + drivers/ide/legacy/ht6560b.c | 7 +++---- 2 files changed, 4 insertions(+), 4 deletions(-)
Index: b/drivers/ide/Kconfig =================================================================== --- a/drivers/ide/Kconfig +++ b/drivers/ide/Kconfig @@ -1008,6 +1008,7 @@ config BLK_DEV_DTC2278 config BLK_DEV_HT6560B tristate "Holtek HT6560B support" + select IDE_TIMINGS help This driver is enabled at runtime using the "ht6560b.probe" kernel boot parameter. It enables support for the secondary IDE interface Index: b/drivers/ide/legacy/ht6560b.c =================================================================== --- a/drivers/ide/legacy/ht6560b.c +++ b/drivers/ide/legacy/ht6560b.c @@ -216,6 +216,7 @@ static u8 ht_pio2timings(ide_drive_t *dr if (pio) { unsigned int cycle_time; + struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio); cycle_time = ide_pio_cycle_time(drive, pio); @@ -224,10 +225,8 @@ static u8 ht_pio2timings(ide_drive_t *dr * actual cycle time for recovery and activity * according system bus speed. */ - active_time = ide_pio_timings[pio].active_time; - recovery_time = cycle_time - - active_time - - ide_pio_timings[pio].setup_time; + active_time = t->active; + recovery_time = cycle_time - active_time - t->setup; /* * Cycle times should be Vesa bus cycles */
| |