lkml.org 
[lkml]   [2008]   [Apr]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/3] wm97xx-core: Support use as a wakeup source
Date
The WM97xx touch screen controllers can be used to generate a wakeup
event when the system is suspended. Provide a new core API call
wm97xx_set_suspend_mode() allowing machine drivers to enable this. If no
suspend_mode is provided then the touch panel will be powered down when
the system is suspended.

Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
---
drivers/input/touchscreen/wm97xx-core.c | 39 +++++++++++++++++++++++++++++++
include/linux/wm97xx.h | 3 ++
2 files changed, 42 insertions(+), 0 deletions(-)
diff --git a/drivers/input/touchscreen/wm97xx-core.c b/drivers/input/touchscreen/wm97xx-core.c
index fec07c2..e9c7ea4 100644
--- a/drivers/input/touchscreen/wm97xx-core.c
+++ b/drivers/input/touchscreen/wm97xx-core.c
@@ -262,6 +262,23 @@ void wm97xx_config_gpio(struct wm97xx *wm, u32 gpio, enum wm97xx_gpio_dir dir,
EXPORT_SYMBOL_GPL(wm97xx_config_gpio);

/*
+ * Configure the WM97XX_PRP value to use while system is suspended.
+ * If a value other than 0 is set then WM97xx pen detection will be
+ * left enabled in the configured mode while the system is in suspend,
+ * the device has users and suspend has not been disabled via the
+ * wakeup sysfs entries.
+ *
+ * @wm: WM97xx device to configure
+ * @mode: WM97XX_PRP value to configure while suspended
+ */
+void wm97xx_set_suspend_mode(struct wm97xx *wm, u16 mode)
+{
+ wm->suspend_mode = mode;
+ device_init_wakeup(&wm->input_dev->dev, mode != 0);
+}
+EXPORT_SYMBOL_GPL(wm97xx_set_suspend_mode);
+
+/*
* Handle a pen down interrupt.
*/
static void wm97xx_pen_irq_worker(struct work_struct *work)
@@ -689,10 +706,32 @@ static int wm97xx_remove(struct device *dev)
static int wm97xx_suspend(struct device *dev, pm_message_t state)
{
struct wm97xx *wm = dev_get_drvdata(dev);
+ u16 reg;
+ int suspend_mode;
+
+ if (device_may_wakeup(&wm->input_dev->dev))
+ suspend_mode = wm->suspend_mode;
+ else
+ suspend_mode = 0;

if (wm->input_dev->users)
cancel_delayed_work_sync(&wm->ts_reader);

+ /* Power down the digitiser (bypassing the cache for resume) */
+ reg = wm97xx_reg_read(wm, AC97_WM97XX_DIGITISER2);
+ reg &= ~WM97XX_PRP_DET_DIG;
+ if (wm->input_dev->users)
+ reg |= suspend_mode;
+ wm->ac97->bus->ops->write(wm->ac97, AC97_WM97XX_DIGITISER2, reg);
+
+ /* WM9713 has an additional power bit - turn it off if there
+ * are no users or if suspend mode is zero. */
+ if (wm->id == WM9713_ID2 &&
+ (!wm->input_dev->users || !suspend_mode)) {
+ reg = wm97xx_reg_read(wm, AC97_EXTENDED_MID) | 0x8000;
+ wm97xx_reg_write(wm, AC97_EXTENDED_MID, reg);
+ }
+
return 0;
}

diff --git a/include/linux/wm97xx.h b/include/linux/wm97xx.h
index ed01c7d..4d13732 100644
--- a/include/linux/wm97xx.h
+++ b/include/linux/wm97xx.h
@@ -282,6 +282,7 @@ struct wm97xx {
unsigned pen_is_down:1; /* Pen is down */
unsigned aux_waiting:1; /* aux measurement waiting */
unsigned pen_probably_down:1; /* used in polling mode */
+ u16 suspend_mode; /* PRP in suspend mode */
};

/*
@@ -297,6 +298,8 @@ void wm97xx_config_gpio(struct wm97xx *wm, u32 gpio,
enum wm97xx_gpio_sticky sticky,
enum wm97xx_gpio_wake wake);

+void wm97xx_set_suspend_mode(struct wm97xx *wm, u16 mode);
+
/* codec AC97 IO access */
int wm97xx_reg_read(struct wm97xx *wm, u16 reg);
void wm97xx_reg_write(struct wm97xx *wm, u16 reg, u16 val);
--
1.5.5


\
 
 \ /
  Last update: 2008-04-15 16:51    [from the cache]
©2003-2011 Jasper Spaans