lkml.org 
[lkml]   [2008]   [Jan]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: e1000 full-duplex TCP performance well below wire speed
On Wed, 30 Jan 2008 16:25:12 -0600 (CST)
Bruce Allen <ballen@gravity.phys.uwm.edu> wrote:

> Hi Stephen,
>
> Thanks for your helpful reply and especially for the literature pointers.
>
> >> Indeed, we are not asking to see 1000 Mb/s. We'd be happy to see 900
> >> Mb/s.
> >>
> >> Netperf is trasmitting a large buffer in MTU-sized packets (min 1500
> >> bytes). Since the acks are only about 60 bytes in size, they should be
> >> around 4% of the total traffic. Hence we would not expect to see more
> >> than 960 Mb/s.
>
> > Don't forget the network overhead: http://sd.wareonearth.com/~phil/net/overhead/
> > Max TCP Payload data rates over ethernet:
> > (1500-40)/(38+1500) = 94.9285 % IPv4, minimal headers
> > (1500-52)/(38+1500) = 94.1482 % IPv4, TCP timestamps
>
> Yes. If you look further down the page, you will see that with jumbo
> frames (which we have also tried) on Gb/s ethernet the maximum throughput
> is:
>
> (9000-20-20-12)/(9000+14+4+7+1+12)*1000000000/1000000 = 990.042 Mbps
>
> We are very far from this number -- averaging perhaps 600 or 700 Mbps.
>


That is the upper bound of performance on a standard PCI bus (32 bit).
To go higher you need PCI-X or PCI-Express. Also make sure you are really
getting 64-bit PCI, because I have seen some e1000 PCI-X boards that
are only 32bit.


\
 
 \ /
  Last update: 2008-01-30 23:37    [W:0.101 / U:0.396 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site