lkml.org 
[lkml]   [2008]   [Jan]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 03/12] [Blackfin] serial driver: Clean up UART DMA code.
Date
From: Sonic Zhang <sonic.zhang@analog.com>

Start next TX DMA in tx dma handler instead of rx timer handler.

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
---
drivers/serial/bfin_5xx.c | 25 ++++++++++---------------
1 files changed, 10 insertions(+), 15 deletions(-)

diff --git a/drivers/serial/bfin_5xx.c b/drivers/serial/bfin_5xx.c
index e059475..3a2aa7e 100644
--- a/drivers/serial/bfin_5xx.c
+++ b/drivers/serial/bfin_5xx.c
@@ -84,7 +84,7 @@ static void bfin_serial_mctrl_check(struct bfin_serial_port *uart);
static void bfin_serial_stop_tx(struct uart_port *port)
{
struct bfin_serial_port *uart = (struct bfin_serial_port *)port;
-#ifndef CONFIG_BF54x
+#if !defined(CONFIG_BF54x) && !defined(CONFIG_SERIAL_BFIN_DMA)
unsigned short ier;
#endif

@@ -307,7 +307,6 @@ static void bfin_serial_tx_chars(struct bfin_serial_port *uart)
UART_PUT_CHAR(uart, uart->port.x_char);
uart->port.icount.tx++;
uart->port.x_char = 0;
- return;
}
/*
* Check the modem control lines before
@@ -376,28 +375,26 @@ static void bfin_serial_dma_tx_chars(struct bfin_serial_port *uart)

if (!uart->tx_done)
return;
-
uart->tx_done = 0;

+ if (uart_circ_empty(xmit) || uart_tx_stopped(&uart->port)) {
+ bfin_serial_stop_tx(&uart->port);
+ uart->tx_done = 1;
+ return;
+ }
+
if (uart->port.x_char) {
UART_PUT_CHAR(uart, uart->port.x_char);
uart->port.icount.tx++;
uart->port.x_char = 0;
- uart->tx_done = 1;
- return;
}
+
/*
* Check the modem control lines before
* transmitting anything.
*/
bfin_serial_mctrl_check(uart);

- if (uart_circ_empty(xmit) || uart_tx_stopped(&uart->port)) {
- bfin_serial_stop_tx(&uart->port);
- uart->tx_done = 1;
- return;
- }
-
spin_lock_irqsave(&uart->port.lock, flags);
uart->tx_count = CIRC_CNT(xmit->head, xmit->tail, UART_XMIT_SIZE);
if (uart->tx_count > (UART_XMIT_SIZE - xmit->tail))
@@ -471,8 +468,6 @@ void bfin_serial_rx_dma_timeout(struct bfin_serial_port *uart)
int x_pos, pos;
int flags = 0;

- bfin_serial_dma_tx_chars(uart);
-
spin_lock_irqsave(&uart->port.lock, flags);
x_pos = DMA_RX_XCOUNT - get_dma_curr_xcount(uart->rx_dma_channel);
if (x_pos == DMA_RX_XCOUNT)
@@ -513,9 +508,9 @@ static irqreturn_t bfin_serial_dma_tx_int(int irq, void *dev_id)
if (uart_circ_chars_pending(xmit) < WAKEUP_CHARS)
uart_write_wakeup(&uart->port);

- if (uart_circ_empty(xmit))
- bfin_serial_stop_tx(&uart->port);
uart->tx_done = 1;
+
+ bfin_serial_dma_tx_chars(uart);
}

spin_unlock(&uart->port.lock);
--
1.5.3.4

\
 
 \ /
  Last update: 2008-01-30 10:35    [W:0.079 / U:2.092 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site