[lkml]   [2008]   [Jan]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: at91sam9260 wakeup on serial port
    On Monday 28 January 2008, Haavard Skinnemoen wrote:
    > > What will AVR32 (AP7) need to do, when it supports system sleep states?
    > Not sure. The PIOs seem to require a clock in order to detect a pin
    > change, so I don't think we can enter very deep sleep states if we want
    > to be woken up by the USART.

    Right; if no DMA is pending, then the HSB matrix clock can be idled, DRAM put
    into self-refresh, and most peripherals can issue wakeups ... AP7 "Frozen"
    state, very analagous to AT91 "standby" on Linux. UARTs and GPIOs can wake.

    Deeper sleep states -- "standby" with clocks running, "stop" with all
    except 32K (and RTC) off, "static" with no clocks at all -- can only
    wake from WAKE_N and external interrupts; and RTC except in "static".
    I suspect "stop" and "static" might want to use the on-chip SRAMs so
    they don't need to change DRAM timings while they fiddle with clocks.

    The closest analogue to the AT91 support would map /sys/power/state:

    standby --> to AP7 "Frozen"
    mem --> to AP7 "Stop"

    Except that there could be no GPIO wakeups from "mem" ... so the $SUBJECT
    patch wouldn't be useful on AVR32 (just AT91), unless USARTn.RXD is wired
    up to one of those special wake-capable pins (extremely board-specific).

    > There's a separate WAKE_N pin that is completely asynchronous, so with
    > some external logic, we can probably wake up the CPU all the way from
    > Static mode if a given input state is present. But that's definitely
    > "board specific" territory, and starting the oscillators take a _long_
    > time on the AP7000 (especially the 32 kHz, but then again, it barely
    > consumes any power, so we might as well keep it running and keep the
    > RTC going as well.)

    I'd think the support of any "deeper" state for "mem" sleep would not
    be entirely board specific ... when the RTC alarm is set, any board
    should be able to use states other than "static". But otherwise, no
    board could enter those states unless WAKE_N or an external IRQ are
    doing something useful (like being hooked up to a button).

    Matching those few "deep wake" events to a given device would imply
    board-specific glue code.

    > So on AP7000, I think we'll just need to keep clocking the USART and
    > let it generate the interrupt that wakes up the rest of the system.

    For "standby" sleep state, yes -- map to at most AVR32 "Frozen" state.
    That'd be a good first step for PM support.

    - Dave

     \ /
      Last update: 2008-01-30 04:47    [W:0.021 / U:6.056 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site