Messages in this thread | | | Date | Sat, 29 Sep 2007 01:37:02 -0700 | From | Andrew Morton <> | Subject | Re: [2.6.23-rc8-mm2] System hangs (loops?) during boot |
| |
On Sat, 29 Sep 2007 02:32:44 +0200 Frans Pop <elendil@planet.nl> wrote:
> On Friday 28 September 2007, Frans Pop wrote: > > My Toshiba Satellite A40 (i386, P4 Mobile) hangs during boot after: > > Marking TSC unstable due to: possible TSC halt in C2. > > Time: acpi_pm clocksource has been installed. > > A few new boot attempts show the problem is more likely at: > Probing IDE interface ide0... > > > It may not actually hang, but rather end up in a loop as after some time > > the fan goes wild. > > Unfortunately I have no serial port and this seems too early for netconsole, > so cannot catch a boot log. > > > Any suggestions where to look before I do a bisect?
Not really, sorry. I usually start at mm.patch when I don't have a clue. It mm.patch fails then pop off all the x86 patches (down to git-ipwireless_cs.patch).
If mm.patch doesn't fail then push on all the memory management patches (up to mm-test-and-set-zone-reclaim-lock-before-starting-cleanup.patch).
Two iterations should get you into the culprit zone.
But please do bisect it. - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |