lkml.org 
[lkml]   [2007]   [May]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
SubjectRe: [RFC PATCH] PCI MMCONFIG: add validation against ACPI motherboard resources
Date
On Tuesday, May 22, 2007 6:06 pm Robert Hancock wrote:
> There was a big discussion about this back in 2002, in which Linus
> wasn't overly enthused about disabling the decode during probing due
> to risk of causing problems with some devices:
>
> http://lkml.org/lkml/2002/12/19/145
>
> In this particular case (64-bit BAR) we might be able to avoid the
> problem by changing the order in which we probe the two halves of the
> address, i.e. change the top half to 0xffffffff before messing with
> the bottom half and then change it back last. That way, we end up
> mapping it way to the top of 64-bit address space, which hopefully is
> less likely to conflict..

Fixed it (finally). I don't think moving the 64 bit probing around
would make a difference, since we'd restore its original value anyway
before moving on to the 32 bit probe which is where I think the problem
is.

I think what's happening is the probe is writing 0xffffffff to the video
device, which is in the GMCH, and without memory decoding disabled,
it'll start claiming PCI config access cycles causing the problems I
saw. So my code to disable I/O and memory decode was actually working
but I had a bug in the re-enable path so all my devices were staying
disabled. :)

So here's the patch I used (along with your ACPI patch and my 965 MCFG
enable patch of course). The probing code could probably use a bit
more cleanup, but this patch limits itself to implementing PCI_COMMAND
based I/O and memory space decode disabling during size probing. We
might want to do this unconditionally if we're using mmconfig based
configuration access, since I imagine other machines might end up
having similar address space layouts that would cause problems.

Linus, since you were the one concerned about breaking working setups,
what do you think? Should we use this approach, or specifically quirk
out cases where mmconfig space might conflict with BAR probing?

Thanks,
Jesse

diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c
index e48fcf0..69dfe0c 100644
--- a/drivers/pci/probe.c
+++ b/drivers/pci/probe.c
@@ -170,6 +170,48 @@ static inline int is_64bit_memory(u32 mask)
return 0;
}

+#define BAR_IS_MEMORY(bar) (((bar) & PCI_BASE_ADDRESS_SPACE) == \
+ PCI_BASE_ADDRESS_SPACE_MEMORY)
+
+/**
+ * pci_bar_size - get raw PCI BAR size
+ * @dev: PCI device
+ * @reg: BAR to probe
+ *
+ * Use basic PCI probing:
+ * - save original BAR value
+ * - disable MEM or IO decode as appropriate in PCI_COMMAND reg
+ * - write all 1s to the BAR
+ * - read back value
+ * - reenble MEM or IO decode as necessary
+ * - write original value back
+ *
+ * Returns raw BAR size to caller.
+ */
+static u32 pci_bar_size(struct pci_dev *dev, unsigned int reg)
+{
+ u32 orig_reg, sz;
+ u16 orig_cmd;
+
+ pci_read_config_dword(dev, reg, &orig_reg);
+ pci_read_config_word(dev, PCI_COMMAND, &orig_cmd);
+
+ if (BAR_IS_MEMORY(orig_reg))
+ pci_write_config_word(dev, PCI_COMMAND,
+ orig_cmd & ~PCI_COMMAND_MEMORY);
+ else
+ pci_write_config_word(dev, PCI_COMMAND,
+ orig_cmd & ~PCI_COMMAND_IO);
+
+ pci_write_config_dword(dev, reg, 0xffffffff);
+ pci_read_config_dword(dev, reg, &sz);
+ pci_write_config_dword(dev, reg, orig_reg);
+
+ pci_write_config_word(dev, PCI_COMMAND, orig_cmd);
+
+ return sz;
+}
+
static void pci_read_bases(struct pci_dev *dev, unsigned int howmany,
int rom)
{
unsigned int pos, reg, next;
@@ -185,17 +227,15 @@ static void pci_read_bases(struct pci_dev *dev,
unsigned int howmany, int rom)
res = &dev->resource[pos];
res->name = pci_name(dev);
reg = PCI_BASE_ADDRESS_0 + (pos << 2);
+
pci_read_config_dword(dev, reg, &l);
- pci_write_config_dword(dev, reg, ~0);
- pci_read_config_dword(dev, reg, &sz);
- pci_write_config_dword(dev, reg, l);
+ sz = pci_bar_size(dev, reg);
if (!sz || sz == 0xffffffff)
continue;
if (l == 0xffffffff)
l = 0;
raw_sz = sz;
- if ((l & PCI_BASE_ADDRESS_SPACE) ==
- PCI_BASE_ADDRESS_SPACE_MEMORY) {
+ if (BAR_IS_MEMORY(l)) {
sz = pci_size(l, sz, (u32)PCI_BASE_ADDRESS_MEM_MASK);
/*
* For 64bit prefetchable memory sz could be 0, if the
@@ -219,9 +259,7 @@ static void pci_read_bases(struct pci_dev *dev,
unsigned int howmany, int rom)
u32 szhi, lhi;

pci_read_config_dword(dev, reg+4, &lhi);
- pci_write_config_dword(dev, reg+4, ~0);
- pci_read_config_dword(dev, reg+4, &szhi);
- pci_write_config_dword(dev, reg+4, lhi);
+ szhi = pci_bar_size(dev, reg+4);
sz64 = ((u64)szhi << 32) | raw_sz;
l64 = ((u64)lhi << 32) | l;
sz64 = pci_size64(l64, sz64, PCI_BASE_ADDRESS_MEM_MASK);
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2007-05-23 20:55    [W:0.061 / U:0.476 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site