lkml.org 
[lkml]   [2007]   [Apr]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Lower HD transfer rate with NCQ enabled?
Paa Paa wrote:
> I'm using Linux 2.6.20.4. I noticed that I get lower SATA hard drive
> throughput with 2.6.20.4 than with 2.6.19. The reason was that 2.6.20
> enables NCQ by defauly (queue_depth = 31/32 instead of 0/32). Transfer
> rate was measured using "hdparm -t":
>
> With NCQ (queue_depth == 31): 50MB/s.
> Without NCQ (queue_depth == 0): 60MB/s.
>
> 20% difference is quite a lot. This is with Intel ICH8R controller and
> Western Digital WD1600YS hard disk in AHCI mode. I also used the next
> command to cat-copy a biggish (540MB) file and time it:
>
> rm temp && sync && time sh -c 'cat quite_big_file > temp && sync'
>
> Here I noticed no differences at all with and without NCQ. The times
> (real time) were basically the same in many successive runs. Around 19s.
>
> Q: What conclusion can I make on "hdparm -t" results or can I make any
> conclusions? Do I really have lower performance with NCQ or not? If I
> do, is this because of my HD or because of kernel?

What IO scheduler are you using? If AS or CFQ, could you try with deadline?

--
SUSE Labs, Novell Inc.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2007-04-03 11:21    [W:1.514 / U:0.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site