Messages in this thread | | | Date | Tue, 2 Oct 2007 12:48:26 -0400 (EDT) | From | Burton Windle <> | Subject | 2.6.23-rc9 boot failure (megaraid?) |
| |
2.6.23-rc9 fails to boot for me; 2.6.22.9 works fine.
System is a Dell Poweredge with PERC 2/DC with RAID1 volume.
From 2.6.23-rc9:
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller at PCI slot 0000:00:07.1 eth1: Optical link UP (Full Duplex, Flow Control: ) PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:pio hdc: SAMSUNG SC-140B, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 hdc: ATAPI 40X CD-ROM drive, 128kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.20 ide-floppy driver 0.99.newide ACPI: PCI Interrupt 0000:00:0d.1[A] -> GSI 17 (level, low) -> IRQ 18 megaraid: found 0x8086:0x1960:bus 0:slot 13:func 1 scsi0:Found MegaRAID controller at 0xf8812000, IRQ:18 megaraid: [1.06:1p00] detected 1 logical drives. megaraid: channel[0] is raid. megaraid: channel[1] is raid. scsi0 : LSI Logic MegaRAID 1.06 254 commands 16 targs 5 chans 7 luns scsi0: scanning scsi channel 0 for logical drives. scsi 0:0:0:0: Direct-Access MegaRAID LD0 RAID1 8568R 1.06 PQ: 0 ANSI: 2 scsi0: scanning scsi channel 4 [P0] for physical devices. scsi0: scanning scsi channel 5 [P1] for physical devices. st: Version 20070203, fixed bufsize 32768, s/g segs 256 sd 0:0:0:0: [sda] Sector size 0 reported, assuming 512. sd 0:0:0:0: [sda] 1 512-byte hardware sectors (0 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Asking for cache data failed sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Sector size 0 reported, assuming 512. sd 0:0:0:0: [sda] 1 512-byte hardware sectors (0 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Asking for cache data failed sd 0:0:0:0: [sda] Assuming drive cache: write through sda: sda1 sda: p1 exceeds device capacity sd 0:0:0:0: [sda] Attached SCSI disk PNP: PS/2 Controller [PNP0303:KBD,PNP0f13:MOU] at 0x60,0x64 irq 1,12 serio: i8042 KBD port at 0x60,0x64 irq 1 serio: i8042 AUX port at 0x60,0x64 irq 12 mice: PS/2 mouse device common for all mice input: PC Speaker as /class/input/input1 input: AT Translated Set 2 keyboard as /class/input/input2 i2c /dev entries driver piix4_smbus 0000:00:07.3: Found 0000:00:07.3 device piix4_smbus 0000:00:07.3: Host SMBus controller not enabled! NET: Registered protocol family 26 TCP cubic registered Initializing XFRM netlink socket NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 15 Starting balanced_irq Using IPI Shortcut mode attempt to access beyond end of device sda: rw=0, want=67, limit=1 EXT3-fs: unable to read superblock attempt to access beyond end of device sda: rw=0, want=67, limit=1 EXT2-fs: unable to read superblock attempt to access beyond end of device sda: rw=0, want=129, limit=1 isofs_fill_super: bread failed, dev=sda1, iso_blknum=16, block=32 attempt to access beyond end of device sda: rw=0, want=131, limit=1 attempt to access beyond end of device sda: rw=0, want=17542979, limit=1 attempt to access beyond end of device sda: rw=0, want=17541955, limit=1 attempt to access beyond end of device sda: rw=0, want=17541731, limit=1 attempt to access beyond end of device sda: rw=0, want=17542971, limit=1 attempt to access beyond end of device sda: rw=0, want=17541947, limit=1 attempt to access beyond end of device sda: rw=0, want=17541723, limit=1 attempt to access beyond end of device sda: rw=0, want=17542379, limit=1 attempt to access beyond end of device sda: rw=0, want=17541355, limit=1 attempt to access beyond end of device sda: rw=0, want=17541131, limit=1 attempt to access beyond end of device sda: rw=0, want=17542371, limit=1 attempt to access beyond end of device sda: rw=0, want=17541347, limit=1 attempt to access beyond end of device sda: rw=0, want=17541123, limit=1 attempt to access beyond end of device sda: rw=0, want=14394267, limit=1 attempt to access beyond end of device sda: rw=0, want=14393243, limit=1 attempt to access beyond end of device sda: rw=0, want=14393019, limit=1 attempt to access beyond end of device sda: rw=0, want=14394259, limit=1 attempt to access beyond end of device sda: rw=0, want=14393235, limit=1 attempt to access beyond end of device sda: rw=0, want=14393011, limit=1 attempt to access beyond end of device sda: rw=0, want=14393667, limit=1 attempt to access beyond end of device sda: rw=0, want=14392643, limit=1 attempt to access beyond end of device sda: rw=0, want=14392419, limit=1 attempt to access beyond end of device sda: rw=0, want=14393659, limit=1 attempt to access beyond end of device sda: rw=0, want=14392635, limit=1 attempt to access beyond end of device sda: rw=0, want=14392411, limit=1 attempt to access beyond end of device sda: rw=0, want=1315, limit=1 attempt to access beyond end of device sda: rw=0, want=1091, limit=1 UDF-fs: No partition found (1) List of all partitions: 1600 4194302 hdc driver: ide-cdrom 0800 0 sda driver: sd 0801 8771458 sda1 No filesystem could mount root, tried: ext3 ext2 iso9660 udf Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(8,1)
From 2.6.22.9:
megaraid: found 0x8086:0x1960:bus 0:slot 13:func 1 scsi0:Found MegaRAID controller at 0xf8812000, IRQ:18 megaraid: [1.06:1p00] detected 1 logical drives. megaraid: channel[0] is raid. megaraid: channel[1] is raid. scsi0 : LSI Logic MegaRAID 1.06 254 commands 16 targs 5 chans 7 luns scsi0: scanning scsi channel 0 for logical drives. scsi 0:0:0:0: Direct-Access MegaRAID LD0 RAID1 8568R 1.06 PQ: 0 ANSI: 2 scsi0: scanning scsi channel 4 [P0] for physical devices. scsi0: scanning scsi channel 5 [P1] for physical devices. st: Version 20070203, fixed bufsize 32768, s/g segs 256 sd 0:0:0:0: [sda] 17547264 512-byte hardware sectors (8984 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Asking for cache data failed sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] 17547264 512-byte hardware sectors (8984 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Asking for cache data failed sd 0:0:0:0: [sda] Assuming drive cache: write through sda: sda1 sd 0:0:0:0: [sda] Attached SCSI disk PNP: PS/2 Controller [PNP0303:KBD,PNP0f13:MOU] at 0x60,0x64 irq 1,12 serio: i8042 KBD port at 0x60,0x64 irq 1 serio: i8042 AUX port at 0x60,0x64 irq 12 mice: PS/2 mouse device common for all mice input: PC Speaker as /class/input/input1 input: AT Translated Set 2 keyboard as /class/input/input2 i2c /dev entries driver piix4_smbus 0000:00:07.3: Found 0000:00:07.3 device piix4_smbus 0000:00:07.3: Host SMBus controller not enabled! NET: Registered protocol family 26 TCP cubic registered Initializing XFRM netlink socket NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 15 Starting balanced_irq Using IPI Shortcut mode kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 260k freed EXT3 FS on sda1, internal journal
00:0d.1 I2O: Intel Corporation 80960RP [i960RP Microprocessor] (rev 02) (prog-if 01) Subsystem: Dell PowerEdge Expandable RAID Controller 2/DC Flags: bus master, medium devsel, latency 64, IRQ 18 Memory at f7000000 (32-bit, prefetchable) [size=4M] [virtual] Expansion ROM at 50000000 [disabled] [size=32K] Capabilities: <access denied>
CONFIG_SCSI=y CONFIG_SCSI_DMA=y CONFIG_SCSI_NETLINK=y CONFIG_SCSI_PROC_FS=y CONFIG_SCSI_LOGGING=y CONFIG_SCSI_FC_ATTRS=y CONFIG_SCSI_LOWLEVEL=y CONFIG_MEGARAID_LEGACY=y
-- Burton Windle bwindle@fint.org
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |