Messages in this thread |  | | | Date | Fri, 12 Jan 2007 20:30:59 -0800 | | From | Randy Dunlap <> | | Subject | Re: 2.6.19.1 failing |
| |
On Sat, 13 Jan 2007 03:58:19 +0100 Von Wolher wrote:
> Hi, > > I just build a 2.6.19.1 vanilla kernel based on the previous config > (make oldconfig) but for some reason it is not starting. Despite > following the usual procedure with lilo like many times before it seems > that lilo tries to boot it and jumps back to the menu screen.
Was your previous config 2.6.18* or 2.6.19? If it was 2.6.18* and you are using SATA, the config symbol names for SATA changed and you'll need set them via make *config.
Otherwise we'll probably need more info.
> But selecting the old kernel boots just fine. > > Any one can advise on what could cause such behaviour beside the obvious > steps like did i run lilo after kernel compile, check paths ...
--- ~Randy - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
|  |