Messages in this thread | | | From | Ondrej Zary <> | Subject | Re: Oops after 30 days of uptime | Date | Sun, 10 Sep 2006 12:43:25 +0200 |
| |
On Sunday 10 September 2006 10:26, Willy Tarreau wrote: > Hi Ondrej, > > OK, I've analysed your oops with your kernel. My conclusions are that you > have a hardware problem (most probably the CPU), because you've hit an > impossible case : > > ip_nat_cheat_check() pushed the size of the data (8) on the stack, followed > by the pointer to the data, then called csum_partial() : > > c01e657f: 6a 08 push $0x8 > c01e6581: 52 push %edx > c01e6582: e8 a5 85 00 00 call c01eeb2c <csum_partial> > > In csum_partial(), ECX is filled with the size (8) and ESI with the data > pointer (0xc0227ce8) : > > c01eeb32: 8b 4c 24 10 mov 0x10(%esp),%ecx > c01eeb36: 8b 74 24 0c mov 0xc(%esp),%esi > > Then, the size is divided by 32 to count how many 32 bytes blocks can be > read at a time. If the size is lower than 32, the code branches to a > special location which reads 1 word at a time : > > c01eeb78: 89 ca mov %ecx,%edx > c01eeb7a: c1 e9 05 shr $0x5,%ecx > c01eeb7d: 74 32 je c01eebb1 <csum_partial+0x85> > > Your oops comes from a few instructions below. The branch has not been > taken while it should have because (8 >> 5) == 0. You can also see from EDX > in the oops that it really was 0x8 when copied from ECX. The rest is pretty > obvious. The data are read 32 bytes at a time after ESI, and ECX is > decreased by 1 every 32 bytes. When ESI+0x18 reaches an unmapped area > (0xc2000000), you get the oops, and ECX = 0xfff113e8 as in your oops. > > Given that the failing instruction is the most common conditionnal jump, it > is very fortunate that your system can work 30 days before crashing. I > think that your CPU might be running too hot and might get wrong results > during branch prediction. It's also possible that you have a poor power > supply. However, I'm pretty sure that this is not a RAM problem.
Thank you very much for the analysis. Good that it's not a kernel bug. The CPU is 33MHz UMC GreenCPU which does not run hot even without a heatsink. It's powered directly from 5V so it might be the power supply.
> Best regards, > Willy > > - > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > Please read the FAQ at http://www.tux.org/lkml/
-- Ondrej Zary - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |