Messages in this thread | | | From | Prakash Punnoor <> | Subject | Re: [RFC/PATCH] Fixes for ULi5261 (tulip driver) | Date | Wed, 16 Aug 2006 20:02:02 +0200 |
| |
Am Mittwoch 16 August 2006 19:43 schrieb Pozsar Balazs: > On Wed, Aug 16, 2006 at 07:11:39PM +0200, Jiri Benc wrote: > > On Tue, 15 Aug 2006 11:25:52 +0200, Pozsar Balazs wrote: > > > Recently I had similar problems as you described below, that's how I > > > found your email. (My exact problem is that there's no link when I plug > > > in a cable, reloading the driver a few times usually helps.) > > > The problem is, that since you made the patch, the uli526x driver has > > > been split out from the tulip driver. > > > Do you know anything about the current state of the uli526x driver > > > regarding the problems you tried patch? > > > > I use the card with new (split out) uli526x driver with no problem. Your > > problems are probably unrelated. > > So, just to make it clear: if you boot without cable plugged in, let > the driver load, and then plug the cable in, do you have link? > For me, it does not have link until I rmmod the module.
Same here.
> Do you have any idea what the problem could be, or could I send you any > info that would help debug it?
I actually played a bit with the code and what fails is uli526x_sense_speed in that way that phy_mode & 024 is 0 (and stays 0). But I don't understand why...
-- (°= =°) //\ Prakash Punnoor /\\ V_/ \_V [unhandled content-type:application/pgp-signature] | |