lkml.org 
[lkml]   [2006]   [Jul]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[patch] collie charging
It seems that sharp had charger on by default... This at least turns
it off. Also battery reading now works and is useful.

Signed-off-by: Pavel Machek <pavel@suse.cz>

PATCH FOLLOWS
KernelVersion: 2.6.18-rc1-git

diff --git a/arch/arm/mach-sa1100/collie_pm.c b/arch/arm/mach-sa1100/collie_pm.c
index 45b1e71..1e25b1d 100644
--- a/arch/arm/mach-sa1100/collie_pm.c
+++ b/arch/arm/mach-sa1100/collie_pm.c
@@ -9,6 +9,9 @@
* Li-ion batteries are angry beasts, and they like to explode. This driver is not finished,
* and sometimes charges them when it should not. If it makes angry lithium to come your way...
* ...well, you have been warned.
+ *
+ * Actually, this should be quite safe, it seems sharp leaves charger enabled by default,
+ * and my collie did not explode (yet).
*/

#include <linux/module.h>
@@ -40,9 +43,8 @@ static void collie_charger_init(void)
{
int err;

- if (sharpsl_param.adadj != -1) {
+ if (sharpsl_param.adadj != -1)
ad_revise = sharpsl_param.adadj;
- }

/* Register interrupt handler. */
if ((err = request_irq(COLLIE_IRQ_GPIO_AC_IN, sharpsl_ac_isr, IRQF_DISABLED,
@@ -72,27 +74,17 @@ static void collie_measure_temp(int on)

static void collie_charge(int on)
{
- if (on) {
- printk("Should start charger\n");
- } else {
- printk("Should stop charger\n");
- }
-#ifdef I_AM_SURE
+ extern struct platform_device colliescoop_device;

- /* Zaurus seems to contain LTC1731 ; it should know when to
+ /* Zaurus seems to contain LTC1731; it should know when to
* stop charging itself, so setting charge on should be
* relatively harmless (as long as it is not done too often).
*/
-#define CF_BUF_CTRL_BASE 0xF0800000
-#define SCOOP_REG(adr) (*(volatile unsigned short*)(CF_BUF_CTRL_BASE+(adr)))
-#define SCOOP_REG_GPWR SCOOP_REG(SCOOP_GPWR)
-
if (on) {
set_scoop_gpio(&colliescoop_device.dev, COLLIE_SCP_CHARGE_ON);
} else {
reset_scoop_gpio(&colliescoop_device.dev, COLLIE_SCP_CHARGE_ON);
}
-#endif
}

static void collie_discharge(int on)
@@ -127,7 +119,6 @@ int collie_read_backup_battery(void)

ucb1x00_adc_enable(ucb);

- /* Gives 75..130 */
ucb1x00_io_write(ucb, COLLIE_TC35143_GPIO_BBAT_ON, 0);
voltage = ucb1x00_adc_read(ucb, UCB_ADC_INP_AD1, UCB_SYNC);

@@ -146,9 +137,8 @@ int collie_read_main_battery(void)
ucb1x00_adc_enable(ucb);
ucb1x00_io_write(ucb, 0, COLLIE_TC35143_GPIO_BBAT_ON);
ucb1x00_io_write(ucb, COLLIE_TC35143_GPIO_MBAT_ON, 0);
- /* gives values 160..255 with battery removed... and
- 145..255 with battery inserted. (on AC), goes as low as
- 80 on DC. */
+
+ mdelay(1);
voltage = ucb1x00_adc_read(ucb, UCB_ADC_INP_AD1, UCB_SYNC);

ucb1x00_io_write(ucb, 0, COLLIE_TC35143_GPIO_MBAT_ON);
@@ -192,7 +182,7 @@ static unsigned long read_devdata(int wh
case SHARPSL_BATT_TEMP:
return collie_read_temp();
case SHARPSL_ACIN_VOLT:
- return 0x1;
+ return 500;
case SHARPSL_STATUS_ACIN: {
int ret = GPLR & COLLIE_GPIO_AC_IN;
printk("AC status = %d\n", ret);
@@ -208,10 +198,33 @@ static unsigned long read_devdata(int wh
}
}

+struct battery_thresh collie_battery_levels_acin[] = {
+ { 420, 100},
+ { 417, 95},
+ { 415, 90},
+ { 413, 80},
+ { 411, 75},
+ { 408, 70},
+ { 406, 60},
+ { 403, 50},
+ { 398, 40},
+ { 391, 25},
+ { 10, 5},
+ { 0, 0},
+};
+
struct battery_thresh collie_battery_levels[] = {
- { 368, 100},
- { 358, 25},
- { 356, 5},
+ { 394, 100},
+ { 390, 95},
+ { 380, 90},
+ { 370, 80},
+ { 368, 75}, /* From sharp code: battery high with frontlight */
+ { 366, 70}, /* 60..90 -- fake values invented by me for testing */
+ { 364, 60},
+ { 362, 50},
+ { 360, 40},
+ { 358, 25}, /* From sharp code: battery low with frontlight */
+ { 356, 5}, /* From sharp code: battery verylow with frontlight */
{ 0, 0},
};

@@ -226,13 +239,21 @@ struct sharpsl_charger_machinfo collie_p
.postsuspend = collie_postsuspend,
.charger_wakeup = collie_charger_wakeup,
.should_wakeup = collie_should_wakeup,
- .bat_levels = 3,
+ .bat_levels = 12,
.bat_levels_noac = collie_battery_levels,
- .bat_levels_acin = collie_battery_levels,
+ .bat_levels_acin = collie_battery_levels_acin,
.status_high_acin = 368,
.status_low_acin = 358,
.status_high_noac = 368,
.status_low_noac = 358,
+ .charge_on_volt = 350, /* spitz uses 2.90V, but lets play it safe. */
+ .charge_on_temp = 550,
+ .charge_acin_high = 550, /* collie does not seem to have sensor for this, anyway */
+ .charge_acin_low = 450, /* ignored, too */
+ .fatal_acin_volt = 356,
+ .fatal_noacin_volt = 356,
+
+ .batfull_irq = 1, /* We do not want periodical charge restarts */
};

static int __init collie_pm_ucb_add(struct ucb1x00_dev *pdev)
--
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2006-07-07 13:47    [W:0.046 / U:0.720 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site