lkml.org 
[lkml]   [2006]   [Jun]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectDual via-rhine on EPIA PD6000E
Hi. I have two differnent via-rhine on EPIA board. Second one is now 
working on my 2.6.15 kernel.

Why there are different io adresses in lspci dmesg and ifconfig?
Any idea why it's not working???


Here are some additional info:

#lspci -v
...
0000:00:0f.0 Ethernet controller: VIA Technologies, Inc. VT6105
[Rhine-III] (rev
8b)
Subsystem: VIA Technologies, Inc.: Unknown device 0106
Flags: bus master, medium devsel, latency 32, IRQ 10
I/O ports at d000 [size=256]
Memory at de000000 (32-bit, non-prefetchable) [size=256]
Capabilities: [44] Power Management version 2
....
0000:00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102
[Rhine-II] (rev
74)
Subsystem: VIA Technologies, Inc. VT6102 [Rhine II] Embeded
Ethernet Con
troller on VT8235
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at e400 [size=256]
Memory at de002000 (32-bit, non-prefetchable) [size=256]
Capabilities: [40] Power Management version 2





#ifconfig

eth0 Link encap:Ethernet HWaddr 00:40:63:DB:86:85
inet addr:192.168.6.156 Bcast:192.168.6.255 Mask:255.255.255.0
inet6 addr: fe80::240:63ff:fedb:8685/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2323562 errors:0 dropped:0 overruns:0 frame:0
TX packets:474569 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3145097604 (2.9 GiB) TX bytes:98221200 (93.6 MiB)
Interrupt:10 Base address:0xe000

eth1 Link encap:Ethernet HWaddr 00:40:63:DB:86:88
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11 Base address:0x4000


#dmesg
...
...
eth0: VIA Rhine III at 0xde000000, 00:40:63:db:86:85, IRQ 10.
eth0: MII PHY found at address 1, status 0x7869 advertising 05e1 Link 41e1.
ACPI: PCI Interrupt 0000:00:12.0[A] -> Link [LNKA] -> GSI 11 (level,
low) -> IRQ 11
eth1: VIA Rhine II at 0xde002000, 00:40:63:db:86:88, IRQ 11.
eth1: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000
.....

PS now second cable is disconnected, but there was a link on eth1 too




-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2006-06-05 16:26    [W:0.050 / U:0.700 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site