Messages in this thread | | | Date | Wed, 3 May 2006 05:41:49 -0700 | From | Andrew Morton <> | Subject | Re: 2.6.17-rc3 PCI init hang |
| |
On Mon, 01 May 2006 15:04:25 -0400 Chuck Lever <cel@citi.umich.edu> wrote:
> I have a dual Pentium III I use for testing. Since late last week > (around about 2.6.17-rc3) it hangs during boot just after "Setting up > standard PCI resources". 2.6.17-rc2 works fine.
Bummer
> A push in the right direction would be appreciated. Please reply off > list as I'm not subscribed. >
Is there any chance you can do a git-bisect to find the bad patch?
> ... > > PCI: PCI BIOS revision 2.10 entry at 0xfdbc1, last bus=1 > Setting up standard PCI resources > > >>> 2.6.17-rc3 stops here and hangs. > >>> 2.6.17-rc2 continues with: > > PCI: Probing PCI hardware > PCI: Discovered peer bus 01 > PCI: Using IRQ router ServerWorks [1166/0200] at 0000:00:0f.0 > PCI->APIC IRQ transform: 0000:00:03.0[A] -> IRQ 31 > PCI->APIC IRQ transform: 0000:01:03.0[A] -> IRQ 23 > PCI: Cannot allocate resource region 0 of device 0000:00:0f.2 > ... > > lspci -v: > > 00:00.0 Host bridge: Broadcom CNB20LE Host Bridge (rev 06) > Flags: bus master, medium devsel, latency 32 > > 00:00.1 Host bridge: Broadcom CNB20LE Host Bridge (rev 06) > Flags: bus master, medium devsel, latency 16 > > 00:01.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27) > (prog-if 00 [VGA]) > Subsystem: ATI Technologies Inc Rage XL > Flags: bus master, stepping, medium devsel, latency 64 > Memory at fd000000 (32-bit, non-prefetchable) [size=16M] > I/O ports at d800 [size=256] > Memory at feaff000 (32-bit, non-prefetchable) [size=4K] > Expansion ROM at feac0000 [disabled] [size=128K] > Capabilities: <available only to root> > > 00:03.0 RAID bus controller: Promise Technology, Inc. PDC20267 > (FastTrak100/Ultra100) (rev 02) > Subsystem: Promise Technology, Inc.: Unknown device 4d32 > Flags: bus master, medium devsel, latency 64, IRQ 31 > I/O ports at dfe0 [size=8] > I/O ports at dfac [size=4] > I/O ports at dfa0 [size=8] > I/O ports at dfa8 [size=4] > I/O ports at df00 [size=64] > Memory at feaa0000 (32-bit, non-prefetchable) [size=128K] > Expansion ROM at feae0000 [size=64K] > Capabilities: <available only to root> > > 00:0f.0 ISA bridge: Broadcom OSB4 South Bridge (rev 50) > Subsystem: Broadcom OSB4 South Bridge > Flags: bus master, medium devsel, latency 0 > > 00:0f.1 IDE interface: Broadcom OSB4 IDE Controller (prog-if 8a [Master > SecP PriP]) > Flags: bus master, medium devsel, latency 64 > I/O ports at ffa0 [size=16] > > 00:0f.2 USB Controller: Broadcom OSB4/CSB5 OHCI USB Controller (rev 04) > (prog-if 10 [OHCI]) > Subsystem: Broadcom OSB4/CSB5 OHCI USB Controller > Flags: medium devsel > Memory at 30000000 (32-bit, non-prefetchable) [size=4K] > > 01:03.0 Ethernet controller: Netgear GA630 Gigabit Ethernet (rev 01) > Subsystem: Netgear GA630 Gigabit Ethernet > Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 23 > Memory at febfc000 (32-bit, non-prefetchable) [size=16K] > > -- > corporate: <cel at netapp dot com> > personal: <chucklever at bigfoot dot com> > - > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > Please read the FAQ at http://www.tux.org/lkml/ - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |