lkml.org 
[lkml]   [2006]   [Mar]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 028/141] V4L/DVB (3430): Add new internal VIDIOC_INT commands
Date
From: Hans Verkuil <hverkuil@xs4all.nl>
Date: 1138043470 -0200

- Add new internal VIDIOC_INT commands for setting the tuner mode,
for putting a chip into standby mode and to set/get the routing
of inputs/outputs of audio or video of a chip. These new commands
will replace older commands that are no longer up to the task.

Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@infradead.org>
---

diff --git a/include/media/v4l2-common.h b/include/media/v4l2-common.h
diff --git a/include/media/v4l2-common.h b/include/media/v4l2-common.h
index 11728da..234e9cf 100644
--- a/include/media/v4l2-common.h
+++ b/include/media/v4l2-common.h
@@ -115,12 +115,15 @@ enum v4l2_chip_ident {
};

/* audio ioctls */
-/* v4l device was opened in Radio mode */
+
+/* v4l device was opened in Radio mode, to be replaced by VIDIOC_INT_S_TUNER_MODE */
#define AUDC_SET_RADIO _IO('d',88)
-/* select from TV,radio,extern,MUTE */
+
+/* select from TV,radio,extern,MUTE, to be replaced with VIDIOC_INT_S_AUDIO_ROUTING */
#define AUDC_SET_INPUT _IOW('d',89,int)

-/* msp3400 ioctl: will be removed in the near future */
+/* msp3400 ioctl: will be removed in the near future, to be replaced by
+ VIDIOC_INT_S_AUDIO_ROUTING. */
struct msp_matrix {
int input;
int output;
@@ -128,12 +131,25 @@ struct msp_matrix {
#define MSP_SET_MATRIX _IOW('m',17,struct msp_matrix)

/* tuner ioctls */
+
/* Sets tuner type and its I2C addr */
-#define TUNER_SET_TYPE_ADDR _IOW('d',90,int)
-/* Puts tuner on powersaving state, disabling it, except for i2c */
-#define TUNER_SET_STANDBY _IOW('d',91,int)
+#define TUNER_SET_TYPE_ADDR _IOW('d', 90, int)
+
+/* Puts tuner on powersaving state, disabling it, except for i2c. To be replaced
+ by VIDIOC_INT_S_STANDBY. */
+#define TUNER_SET_STANDBY _IOW('d', 91, int)
+
/* Sets tda9887 specific stuff, like port1, port2 and qss */
-#define TDA9887_SET_CONFIG _IOW('d',92,int)
+#define TDA9887_SET_CONFIG _IOW('d', 92, int)
+
+/* Switch the tuner to a specific tuner mode. Replacement of AUDC_SET_RADIO */
+#define VIDIOC_INT_S_TUNER_MODE _IOW('d', 93, enum v4l2_tuner_type)
+
+/* Generic standby command. Passing -1 (all bits set to 1) will put the whole
+ chip into standby mode, value 0 will make the chip fully active. Specific
+ bits can be used by certain chips to enable/disable specific subsystems.
+ Replacement of TUNER_SET_STANDBY. */
+#define VIDIOC_INT_S_STANDBY _IOW('d', 94, u32)

/* only implemented if CONFIG_VIDEO_ADV_DEBUG is defined */
#define VIDIOC_INT_S_REGISTER _IOR ('d', 100, struct v4l2_register)
@@ -181,4 +197,25 @@ struct msp_matrix {
If the frequency is not supported, then -EINVAL is returned. */
#define VIDIOC_INT_I2S_CLOCK_FREQ _IOW ('d', 108, u32)

+/* Routing definition, device dependent. It specifies which inputs (if any)
+ should be routed to which outputs (if any). */
+struct v4l2_routing {
+ u32 input;
+ u32 output;
+};
+
+/* These internal commands should be used to define the inputs and outputs
+ of an audio/video chip. They will replace AUDC_SET_INPUT.
+ The v4l2 API commands VIDIOC_S/G_INPUT, VIDIOC_S/G_OUTPUT,
+ VIDIOC_S/G_AUDIO and VIDIOC_S/G_AUDOUT are meant to be used by the
+ user. Internally these commands should be used to switch inputs/outputs
+ because only the driver knows how to map a 'Television' input to the precise
+ input/output routing of an A/D converter, or a DSP, or a video digitizer.
+ These four commands should only be sent directly to an i2c device, they
+ should not be broadcast as the routing is very device specific. */
+#define VIDIOC_INT_S_AUDIO_ROUTING _IOW ('d', 109, struct v4l2_routing)
+#define VIDIOC_INT_G_AUDIO_ROUTING _IOR ('d', 110, struct v4l2_routing *)
+#define VIDIOC_INT_S_VIDEO_ROUTING _IOW ('d', 111, struct v4l2_routing)
+#define VIDIOC_INT_G_VIDEO_ROUTING _IOR ('d', 112, struct v4l2_routing *)
+
#endif /* V4L2_COMMON_H_ */
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2006-03-20 16:30    [W:0.463 / U:0.688 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site