[lkml]   [2006]   [Jan]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    Subjectchange eth0 to sn0 ?
    i m using  fc3

    $ ifconfig

    eth0 Link encap:Ethernet HWaddr 00:11:2F:38:07:D9
    inet addr: Bcast: Mask:
    RX packets:6506 errors:0 dropped:0 overruns:0 frame:0
    TX packets:5120 errors:0 dropped:0 overruns:0 carrier:0
    collisions:1256 txqueuelen:1000
    RX bytes:1951142 (1.8 Mb) TX bytes:1027381 (1003.3 Kb)
    Interrupt:23 Base address:0x3800

    lo Link encap:Local Loopback
    inet addr: Mask:
    UP LOOPBACK RUNNING MTU:16436 Metric:1
    RX packets:78 errors:0 dropped:0 overruns:0 frame:0
    TX packets:78 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:0
    RX bytes:5420 (5.2 Kb) TX bytes:5420 (5.2 Kb)

    $ ifconfig eth0 down
    $ ifconfig sn0 netmask

    sn0 intreface is added by driver .

    what i want is , i want to use the hw addreess of eth0 , irq of eth0 to sn0

    ie , i want to do

    $ ifconfig sno mtu 1500 irq 193 hw ether 00:11:2f:77:fd:c2

    what i have to do ?

    Spice up your IM conversations. New, colorful and animated emoticons. Get

    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2006-01-14 09:58    [W:0.019 / U:0.992 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site