lkml.org 
[lkml]   [2005]   [May]   [16]   [last100]   RSS Feed
Views: [more markup]  [less markup]  [headers]  [forward] 
 
Messages in this thread
/
DateMon, 16 May 2005 09:44:05 -0400
FromMark Lord <>
SubjectRe: Disk write cache (Was: Hyper-Threading Vulnerability)
Gene Heskett wrote:
>
>>There's your clue.  The drive LEDs normally reflect activity
>>over the ATA bus (the cable!). If they're not on, then the drive
>>isn't receiving data/commands from the host.
>
> That was my theory too Mark, but Jeff G. says its not a valid 
> indicator.  So who's right?

If the LEDs are connected to the controller on the motherboard,
then they are a strict indication of activity over the cable
between the drive and controller (if they function at all).
But it is possible for software to leave those LEDs permanently
in the "on" state, depending on the register sequence used.

If the LEDs are on the drive itself, they may indicate transfers
over the connector (cable) -- usually always the case -- or they
could indicate transfers to/from the media.

Cheers

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-05-16 15:49    [from the cache]
©2003-2008