Messages in this thread |  | | | Date | Mon, 16 May 2005 17:12:01 +0200 | | Subject | Re: What breaks aic7xxx in post 2.6.12-rc2 ? (on amd64 ?) | | From | Grégoire Favre <> |
| |
On Mon, May 16, 2005 at 05:03:56PM +0200, Jesper Juhl wrote:
> Not me, it works perfectly here, but then I have different hardware (but > using the aic7xxx driver).
You are lucky, maybe I should also mention that I am under x86_64 ?
Here under 2.6.12-rc2 :
ACPI: PCI Interrupt 0000:00:05.0[A] -> GSI 16 (level, low) -> IRQ 16 ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 17 (level, low) -> IRQ 17 scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36 <Adaptec 29160B Ultra160 SCSI adapter> aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs (scsi0:A:0): 80.000MB/s transfers (40.000MHz, offset 15, 16bit) (scsi0:A:15): 80.000MB/s transfers (40.000MHz DT, offset 63, 16bit) Vendor: IBM Model: DDRS-39130D Rev: DC1B Type: Direct-Access ANSI SCSI revision: 02 scsi0:A:0:0: Tagged Queuing enabled. Depth 253 Vendor: SEAGATE Model: ST336706LW Rev: 0108 Type: Direct-Access ANSI SCSI revision: 03 scsi0:A:15:0: Tagged Queuing enabled. Depth 253 scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36 <Adaptec 2940 Ultra SCSI adapter> aic7880: Ultra Single Channel A, SCSI Id=7, 16/253 SCBs
(scsi1:A:1): 10.000MB/s transfers (10.000MHz, offset 15) Vendor: TOSHIBA Model: DVD-ROM SD-M1201 Rev: 1R08 Type: CD-ROM ANSI SCSI revision: 02 (scsi1:A:2): 10.000MB/s transfers (10.000MHz, offset 8) Vendor: PLEXTOR Model: CD-R PX-R820T Rev: 1.08 Type: CD-ROM ANSI SCSI revision: 02 (scsi1:A:3): 10.000MB/s transfers (10.000MHz, offset 8) Vendor: PLEXTOR Model: CD-R PX-R820T Rev: 1.08 Type: CD-ROM ANSI SCSI revision: 02 libata version 1.10 loaded. sata_via version 1.1 ACPI: PCI Interrupt 0000:00:0f.0[B] -> GSI 20 (level, low) -> IRQ 20 sata_via(0000:00:0f.0): routed to hard irq line 4 ata1: SATA max UDMA/133 cmd 0xE000 ctl 0xDC02 bmdma 0xD000 irq 20 ata2: SATA max UDMA/133 cmd 0xD800 ctl 0xD402 bmdma 0xD008 irq 20 ata1: no device found (phy stat 00000000) scsi2 : sata_via ata2: dev 0 cfg 49:2f00 82:7c6b 83:7f09 84:4043 85:7c69 86:3e01 87:4043 88:407f ata2: dev 0 ATA, max UDMA/133, 398297088 sectors: lba48 ata2: dev 0 configured for UDMA/133 scsi3 : sata_via Vendor: ATA Model: Maxtor 6B200M0 Rev: BANC Type: Direct-Access ANSI SCSI revision: 05 SCSI device sda: 17850000 512-byte hdwr sectors (9139 MB) SCSI device sda: drive cache: write back sda: sda1 sda2 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sdb: 71687370 512-byte hdwr sectors (36704 MB) SCSI device sdb: drive cache: write back SCSI device sdb: 71687370 512-byte hdwr sectors (36704 MB) SCSI device sdb: drive cache: write back sdb: sdb1 sdb2 Attached scsi disk sdb at scsi0, channel 0, id 15, lun 0 SCSI device sdc: 398297088 512-byte hdwr sectors (203928 MB) SCSI device sdc: drive cache: write back SCSI device sdc: 398297088 512-byte hdwr sectors (203928 MB) SCSI device sdc: drive cache: write back sdc: sdc1 sdc2 Attached scsi disk sdc at scsi3, channel 0, id 0, lun 0 sr0: scsi3-mmc drive: 32x/32x cd/rw xa/form2 cdda tray Attached scsi CD-ROM sr0 at scsi1, channel 0, id 1, lun 0 sr1: scsi3-mmc drive: 20x/20x writer cd/rw xa/form2 cdda tray Attached scsi CD-ROM sr1 at scsi1, channel 0, id 2, lun 0 sr2: scsi3-mmc drive: 20x/20x writer cd/rw xa/form2 cdda tray Attached scsi CD-ROM sr2 at scsi1, channel 0, id 3, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0 Attached scsi generic sg1 at scsi0, channel 0, id 15, lun 0, type 0 Attached scsi generic sg2 at scsi1, channel 0, id 1, lun 0, type 5 Attached scsi generic sg3 at scsi1, channel 0, id 2, lun 0, type 5 Attached scsi generic sg4 at scsi1, channel 0, id 3, lun 0, type 5 Attached scsi generic sg5 at scsi3, channel 0, id 0, lun 0, type 0 usbmon: debugs is not available ACPI: PCI Interrupt 0000:00:10.4[C] -> GSI 21 (level, low) -> IRQ 21 ehci_hcd 0000:00:10.4: VIA Technologies, Inc. USB 2.0 ehci_hcd 0000:00:10.4: new USB bus registered, assigned bus number 1 ehci_hcd 0000:00:10.4: irq 21, io mem 0xcfffe900 ehci_hcd 0000:00:10.4: USB 2.0 initialized, EHCI 1.00, driver 10 Dec 2004 hub 1-0:1.0: USB hub found hub 1-0:1.0: 8 ports detected USB Universal Host Controller Interface driver v2.2 ACPI: PCI Interrupt 0000:00:10.0[A] -> GSI 21 (level, low) -> IRQ 21 uhci_hcd 0000:00:10.0: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller uhci_hcd 0000:00:10.0: new USB bus registered, assigned bus number 2 uhci_hcd 0000:00:10.0: irq 21, io base 0x0000bc00 hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected ACPI: PCI Interrupt 0000:00:10.1[A] -> GSI 21 (level, low) -> IRQ 21 uhci_hcd 0000:00:10.1: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (#2) uhci_hcd 0000:00:10.1: new USB bus registered, assigned bus number 3 uhci_hcd 0000:00:10.1: irq 21, io base 0x0000c000 hub 3-0:1.0: USB hub found hub 3-0:1.0: 2 ports detected ACPI: PCI Interrupt 0000:00:10.2[B] -> GSI 21 (level, low) -> IRQ 21 uhci_hcd 0000:00:10.2: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (#3) uhci_hcd 0000:00:10.2: new USB bus registered, assigned bus number 4 uhci_hcd 0000:00:10.2: irq 21, io base 0x0000c400 hub 4-0:1.0: USB hub found hub 4-0:1.0: 2 ports detected ACPI: PCI Interrupt 0000:00:10.3[B] -> GSI 21 (level, low) -> IRQ 21 uhci_hcd 0000:00:10.3: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (#4) uhci_hcd 0000:00:10.3: new USB bus registered, assigned bus number 5 uhci_hcd 0000:00:10.3: irq 21, io base 0x0000c800 hub 5-0:1.0: USB hub found hub 5-0:1.0: 2 ports detected Initializing USB Mass Storage driver... usbcore: registered new driver usb-storage USB Mass Storage support registered. Anyone has aic7xxx working post 2.6.12-rc2 on amd64 ?
Thank you very much and please keep CC to me as I am not on this ml. -- Grégoire Favre - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
|  |