[lkml]   [2004]   [May]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: SiI3112 Serial ATA - no response on boot
    consider also to upgrade to libata driver.
    Marcin Garski wrote:
    > [Please CC me on replies, I am not subscribed to the list, thanks]
    > Hi,
    > I have a Abit NF7-S V2.0 mainboard (nForce2 chipset + SiI3112 SATA),
    > with Seagate S-ATA connected to Sil3112.
    > During boot i get following messages:
    > SiI3112 Serial ATA: IDE controller at PCI slot 0000:01:0b.0
    > SiI3112 Serial ATA: chipset revision 2
    > SiI3112 Serial ATA: 100% native mode on irq 11
    > ide2: MMIO-DMA , BIOS settings: hde:pio, hdf:pio
    > ide3: MMIO-DMA , BIOS settings: hdg:pio, hdh:pio
    > hde: ST380013AS, ATA DISK drive
    > ide2 at 0xe083c080-0xe083c087,0xe083c08a on irq 11
    > hdg: no response (status = 0xfe)
    > hdg: no response (status = 0xfe), resetting drive
    > hdg: no response (status = 0xfe)
    > Each "no response" message delays booting about 20 seconds.
    > I don't have any device connected to hdg.
    > I was wondering how to speed up booting, because this "hdg: no response
    > (status = 0xfe), resetting drive" info is little irritating?
    > I'm running on 2.6.6 kernel (on 2.6.4 this "no response" messages also
    > appear).

    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2005-03-22 14:03    [W:0.020 / U:6.084 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site