![]() | |||||||||||||
Messages in this thread |
> > tg3.ko loads, network starts up. Can't connect to 100Mbit network > > switch. The bcm5700 driver in ths SuSE kraxel 2.6.3 kernel works. The > > tg3 is supposed to be a replacement for bcm5700 I believe. Works for me (Dell Latitude D600), both for "NIC to switch"... === Mar 12 16:20:37 y kernel: Linux version 2.6.4-mm1 (lech7@y) (gcc version 3.3.3) #1 Thu Mar 11 14:16:54 CET 2004 [...] Mar 12 16:20:37 y kernel: eth0: Tigon3 [partno(BCM95702A20) rev 1002 PHY(5703)] (PCI:33MHz:32-bit) 10/100/1000BaseT Ethernet 00:0d:56:7b:d8:9d [...] Mar 12 16:20:39 y kernel: tg3: eth0: Link is up at 100 Mbps, half duplex. Mar 12 16:20:39 y kernel: tg3: eth0: Flow control is off for TX and off for RX. === ...and "NIC to NIC" mode: === Mar 14 03:43:08 y kernel: Linux version 2.6.4-mm1 (lech7@y) (gcc version 3.3.3) #1 Thu Mar 11 14:16:54 CET 2004 [...] Mar 14 03:43:08 y kernel: eth0: Tigon3 [partno(BCM95702A20) rev 1002 PHY(5703)] (PCI:33MHz:32-bit) 10/100/1000BaseT Ethernet 00:0d:56:7b:d8:9d [...] Mar 14 03:43:10 y kernel: tg3: eth0: Link is up at 100 Mbps, full duplex. Mar 14 03:43:10 y kernel: tg3: eth0: Flow control is off for TX and off for RX. === -- Leszek. -- lech7@pse.pl 2:480/33.7 -- REAL programmers use INTEGERS -- -- speaking just for myself... - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/ | ||||||||||||
| Last update: 2005-03-22 13:01 [from the cache] ©2003-2008 | |||||||||||||