![]() | |||||||||||||
Messages in this thread |
Hello, I have just taken the plunge and built 2.6.1 for my desktop K6-200, 430TX. With the preempt, it is certainly faster than 2.4 and the memory/swap usage is much less. Great! However, I have noticed a couple of problems: I have a 3com NIC. But the module usage count for 3c59x stays at 0 even when eth0 is up. Secondly, I cannot run lilo under 2.6.1. I get Device 0x0300: Invalid partition table, 2nd entry 3D address: 1/0/773 (779184) Linear address: 1/0/6184 (6233472) Runs fin under 2.4. There is a difference in the way the disk geometries are reported on boot. 2.4 reports: Jan 15 08:00:17 titan kernel: hda: 6835952 sectors (3500 MB), CHS=847/128/63, UDMA(33) Jan 15 08:00:17 titan kernel: hdb: 40031712 sectors (20496 MB) w/512KiB Cache, CHS=2491/255/63, UDMA(33) and 2.6.1: Jan 15 08:19:56 titan kernel: hda: 6835952 sectors (3500 MB), CHS=6781/16/63, UDMA(33) Jan 15 08:19:56 titan kernel: hdb: 40031712 sectors (20496 MB) w/512KiB Cache, CHS=39714/16/63, UDMA(33) I have # CONFIG_IDEDISK_STROKE is not set but according to the help, I shouldn't need it as the disk is less than 32MB. Award BIOS. Do let me know if you need any other info on this. Mark - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/ | ||||||||||||
| Last update: 2005-03-22 14:00 [from the cache] ©2003-2008 | |||||||||||||