[lkml]   [2003]   [Jun]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: aic7xxx and SiI3112 problems (2.4.21[-ac1] and 2.5.7x)
    > I have an Adaptec 29160N that uses the aic7xxx driver.  I have had no
    > problems with this driver in 2.4.20, but in 2.4.21, my drives fail parity
    > checks. I've gone back and forward between 2.4.20 kernels and 2.4.21
    > kernels just to make sure it wasn't the drive's fault. The exact error
    > message(s) are at the middle-end of this email.

    The typical reason that you might get a CRC error is that the termination
    is not configured correctly on your card. I don't recall off hand any
    particular termination issues for the 29160N that have been resolved
    by driver releases after 6.2.8, but newer drivers do have more termination
    diagnostics that may help me to resolve your problem. You should be able
    to just drop in the latest driver from here:

    If the newer driver still causes problems, let me know and I can give
    you instructions on how to enable the debugging I need to better understand
    your problem.


    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2005-03-22 13:36    [W:0.019 / U:73.224 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site