Messages in this thread | | | Date | Wed, 05 Feb 2020 13:25:37 -0500 | From | Linux Lists <> | Subject | Re: Help with promise sx6000 card |
| |
Ok Alan i followed your advises and finally i got the i2o_pci module loaded.
But I am still not able to get my card under /dev/i2o/hda.
Any clues?
Here is my dmesg output
*********************************************************
PDC20276: IDE controller on PCI bus 02 dev 00 PDC20276: chipset revision 1 ide: Found promise 20265 in RAID mode. PDC20276: not 100% native mode: will probe irqs later PDC20276: simplex device: DMA disabled ide2: PDC20276 Bus-Master DMA disabled (BIOS) PDC20276: simplex device: DMA disabled ide3: PDC20276 Bus-Master DMA disabled (BIOS) PDC20276: IDE controller on PCI bus 02 dev 08 PDC20276: chipset revision 1 ide: Found promise 20265 in RAID mode. PDC20276: not 100% native mode: will probe irqs later PDC20276: simplex device: DMA disabled ide4: PDC20276 Bus-Master DMA disabled (BIOS) PDC20276: simplex device: DMA disabled ide5: PDC20276 Bus-Master DMA disabled (BIOS) PDC20276: IDE controller on PCI bus 02 dev 10 PDC20276: chipset revision 1 ide: Found promise 20265 in RAID mode. PDC20276: not 100% native mode: will probe irqs later PDC20276: simplex device: DMA disabled ide6: PDC20276 Bus-Master DMA disabled (BIOS) PDC20276: simplex device: DMA disabled ide7: PDC20276 Bus-Master DMA disabled (BIOS) hda: WDC WD1200JB-75CRA0, ATA DISK drive hdb: no response (status = 0xa1), resetting drive hdb: no response (status = 0xa1) hdc: AOPEN 16XDVD-ROM/AMH 20020328, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: setmax LBA 234441648, native 234375000 hda: 234375000 sectors (120000 MB) w/8192KiB Cache, CHS=14589/255/63, UDMA(100) ide-floppy driver 0.99.newide Partition check: hda: hda1 hda2 hda3 hda4 < hda5 hda6 hda7 hda8 hda9 hda10 > Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 NET4: Frame Diverter 0.46 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize ide-floppy driver 0.99.newide md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. pci_hotplug: PCI Hot Plug PCI Core version: 0.4 NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 16384 buckets, 128Kbytes TCP: Hash tables configured (established 262144 bind 65536) Linux IP multicast router 0.06 plus PIM-SM NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. RAMDISK: Compressed image found at block 0 Freeing initrd memory: 221k freed VFS: Mounted root (ext2 filesystem). I2O Core - (C) Copyright 1999 Red Hat Software I2O: Event thread created as pid 13 Linux I2O PCI support (c) 1999 Red Hat Software. i2o: Checking for PCI I2O controllers... i2o: I2O controller on bus 0 at 81. i2o: PCI I2O controller at 0xF9000000 size=4194304 I2O: Promise workarounds activated. I2O: MTRR workaround for Intel i960 processor i2o/iop0: Installed at IRQ10 i2o: 1 I2O controller found and installed. Activating I2O controllers... This may take a few minutes if there are many devices i2o/iop0: Get status timeout. Unable to obtain status of i2o/iop0, attempting a reset. i2o/iop0: Get status timeout. IOP reset timeout. i2o/iop0: Get status timeout. IOP reset timeout. I2O Block Storage OSM v0.9 (c) Copyright 1999-2001 Red Hat Software. i2o_block: registered device at major 80 i2o_block: Checking for Boot device... i2o_block: Checking for I2O Block devices... SCSI subsystem driver Revision: 1.00 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 Journalled Block Device driver loaded kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. Freeing unused kernel memory: 240k freed
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |