Messages in this thread | | | Subject | Serial ATA support in 2.4.22 | Date | Wed, 1 Oct 2003 10:55:51 -0400 | From | "Andrew Marold" <> |
| |
I just got some new Dell Precision 360's, 2 of which have SATA drives that I'm trying to install RH9 on. I built a new kernel from the 2.4.22 sources, patched with the 2.4.22-ac4 patches. When I boot, linux recognizes the drives, but hangs doing a partition check. Here's what I see on the console:
ata1: SATA max UDMA/133 cmd 0xFE00 ctl 0xFE12 bmdma 0xFEA0 irq 17 ata2: SATA max UDMA/133 cmd 0xFE20 ctl 0xFE32 bmdma 0xFEA8 irq 17 ata1: dev 0 ATA, max UDMA/133, 234375000 sectors (lba48) ata1: dev 0 configured for UDMA/133 ata2: port disabled, ignoring. scsi0: ata_piix scsi1: ata_piix Vendor: ATA Model: ST3120026AS Rev: 0.71 Type: Direct-Access ANSI SCSI revision: 05 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 234375000 512-byte sectors (120000 MB) Partition check: sda:<3>ata1: DMA timeout, stat 0x24
Has this been seen before, or are these boxes just too far out on the bleeding edge and I'm going to have to wait a while ?
Thanks, Drew
Andrew Marold - Andrew.Marold@edial.com Release Engineer - eDial Inc.
Call me for free: http://beta.edial.com/call/Andrew_Marold
Nothing looks worse on your outdoor resume than a list of the possible locations of your remains. - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |