[lkml]   [2002]   [Apr]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: 2.4.19-pre7-ac2: Promise Ultra100TX2 broken
    > In the late 2.4.19-preX-acY the support for the Promise
    > Ultra100TX2 is broken.

    Apparently not for everyone. I'm using one such card with
    a 20G Western Digital drive on 2.4.19-pre7-ac2 w/o any problems
    apart from having to pass 'ide2=ata66' to get the driver to
    allow me to use UDMA4/5 (yes, the drive *is* attached using
    an 80-wire cable). The U100TX2's BIOS rev. is

    kala@liv:~$ uname -a
    Linux liv 2.4.19-pre7-ac2-O1-2 #1 Tue Apr 23 19:16:09 CEST 2002 i686 unknown

    kala@liv:~$ /sbin/lspci
    00:00.0 Host bridge: Intel Corporation 440FX - 82441FX PMC [Natoma] (rev 02)
    00:04.0 ISA bridge: Intel Corporation 82371SB PIIX3 ISA [Natoma/Triton II] (rev 01)
    00:04.1 IDE interface: Intel Corporation 82371SB PIIX3 IDE [Natoma/Triton II]
    00:06.0 Unknown mass storage controller: Promise Technology, Inc.: Unknown device 4d68 (rev 02)
    00:07.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8029(AS)
    00:0d.0 VGA compatible controller: Cirrus Logic GD 5446 (rev 45)

    <snip> -- dmesg excerpt --
    PDC20268: IDE controller on PCI bus 00 dev 30
    PDC20268: chipset revision 2
    PDC20268: not 100% native mode: will probe irqs later
    PDC20268: ATA-66/100 forced bit set (WARNING)!!
    ide2: BM-DMA at 0xfcd0-0xfcd7, BIOS settings: hde:pio, hdf:pio
    ide3: BM-DMA at 0xfcd8-0xfcdf, BIOS settings: hdg:pio, hdh:pio
    hde: WDC WD205BA, ATA DISK drive
    ide2 at 0xfcb8-0xfcbf,0xfcca on irq 9
    hde: 40088160 sectors (20525 MB) w/2048KiB Cache, CHS=39770/16/63, UDMA(66)
    Partition check:
    hde: [PTBL] [2495/255/63] hde1 hde2 hde3 hde4
    <snip> -- dmesg excerpt --

    root@liv:~# hdparm -i /dev/hde


    Model=WDC WD205BA, FwRev=16.13M16, SerialNo=WD-WM9491625969
    Config={ HardSect NotMFM HdSw>15uSec SpinMotCtl Fixed DTR>5Mbs FmtGapReq }
    RawCHS=16383/16/63, TrkSize=57600, SectSize=600, ECCbytes=40
    BuffType=DualPortCache, BuffSize=2048kB, MaxMultSect=16, MultSect=off
    CurCHS=16383/16/63, CurSects=-66060037, LBA=yes, LBAsects=40088160
    IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
    PIO modes: pio0 pio1 pio2 pio3 pio4
    DMA modes: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 *udma4
    Drive Supports : Reserved : ATA-1 ATA-2 ATA-3 ATA-4

    Email me should you need my '.config'.


    "hello it's not like i read my mail so that you have where to offer to sell me
    a giant turnip or anything else thankyou." -tomas szepe <>
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2005-03-22 13:25    [W:0.044 / U:99.204 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site