Messages in this thread | | | Subject | PCMCIA and hermer/orinoco_cs drivers b0rken? | From | Alexander Hoogerhuis <> | Date | 24 Dec 2002 18:10:29 +0100 |
| |
Since very early 2.4 somewhere it has been impossible to use my two wireless cards, a NetGear ME401 and a Lucent card (both orinoco-based). Both are able to load the modules when pluggen in, but trying to use them is futile, as nothing gets transmitted, and dmesg show tons of this:
eth1: Station identity 001f:0006:0001:0003 eth1: Looks like an Intersil firmware version 1.03 eth1: Ad-hoc demo mode supported eth1: IEEE standard IBSS ad-hoc mode supported eth1: WEP supported, 104-bit key eth1: MAC address 00:09:5B:27:DC:F9 eth1: Station name "Prism I" eth1: ready eth1: index 0x01: Vcc 5.0, irq 6, io 0x0100-0x013f NETDEV WATCHDOG: eth1: transmit timed out eth1: Tx timeout! Resetting card. ALLOCFID=0128, TXCOMPLFID=0127, EVSTAT=800c eth1: Error -110 writing packet to BAP eth1: Error -110 writing Tx descriptor to BAP eth1: Error -110 writing Tx descriptor to BAP NETDEV WATCHDOG: eth1: transmit timed out eth1: Tx timeout! Resetting card. ALLOCFID=0128, TXCOMPLFID=0127, EVSTAT=800c
The situation is similar for both cars, and I'm wondering if this is a known broken setup, or I've messed up?
Currnently I'm on 2.4.20, tried both with and without the ACPI and preempt patches (vmware deosnt make a difference either), the hardware is a Compaq Evo n800c notebook and this is the cardbus bridge:
02:06.0 CardBus bridge: Texas Instruments PCI1410 PC card Cardbus Controller (rev 02) Subsystem: Compaq Computer Corporation: Unknown device 004a Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 168, cache line size 20 Interrupt: pin A routed to IRQ 11 Region 0: Memory at 40000000 (32-bit, non-prefetchable) [size=4K] Bus: primary=02, secondary=03, subordinate=03, sec-latency=176 Memory window 0: 30400000-307ff000 (prefetchable) Memory window 1: 30800000-30bff000 I/O window 0: 00004800-000048ff I/O window 1: 00004c00-00004cff BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset+ 16bInt+ PostWrite+ 16-bit legacy interface ports at 0001
mvh, A -- Alexander Hoogerhuis | alexh@ihatent.com CCNP - CCDP - MCNE - CCSE | +47 908 21 485 "You have zero privacy anyway. Get over it." --Scott McNealy - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |