lkml.org 
[lkml]   [2002]   [Oct]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    Subject3ware Escalade 7500 init problems on 2.4.19
    Hi there..

    Just received a 3ware 7500-8 RAID card and am trying to get it installed
    on a dual Athlon system with 4GB of RAM, running 2.4.19.

    SCSI support and SCSI disk support are enabled.
    Low level support for 3w-xxxx is enabled.
    The RAID has been flashed to the latest hardware revision.

    Kernel loads up fine, and gets to initializing the card, where it waits
    for a while as it attempts to init and reinit, etc, the card. Ultimately,
    it simply resets the card and takes the card offline. 'dmesg' reports
    the following in the kernel log:

    scsi0 : Found a 3ware Storage Controller at 0xc400, IRQ: 11, P-chip: 1.3
    scsi0 : 3ware Storage Controller
    3w-xxxx: scsi0: Unit #0: Command (0xf4d53800) timed out, resetting card.
    3w-xxxx: scsi0: Unit #0: Command (0xf4d53800) timed out, resetting card.
    3w-xxxx: scsi0: Reset succeeded.
    3w-xxxx: scsi0: Unit #0: Command (0xf4d53800) timed out, resetting card.
    scsi: device set offline - not ready or command retry failed after host reset:
    host 0 channel 0 id 0 lun 0


    Any ideas what the problem might be?

    Ken Savage kens1835@shaw.ca
    AllResearch.com

    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.kernel.org
    More majordomo info at http://vger.kernel.org/majordomo-info.html
    Please read the FAQ at http://www.tux.org/lkml/

    \
     
     \ /
      Last update: 2005-03-22 13:29    [W:0.036 / U:2.524 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site