lkml.org 
[lkml]   [2001]   [Mar]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: eepro100 question: why SCBCmd byte is 0x80?
Which kernel are you using.

I've had a similar problem with 2.2.18.
I've backported 2.2.19pre changes to it.
(i.e. apply on 2.2.18 a diff of the file drivers/net/eepro100.c made between 2.2.18 and the last 2.2.19pre)
And since I've never seen this problem again.

Christophe

On jeu, 22 mar 2001 22:04:45 Jun Sun wrote:
>
> I am trying to get netgear card working on a new (read as potentially buggy
> hardware) MIPS board.
>
> The eepro100 driver basically works fine. It is just after a little while
> (usually 2 sec to 15 sec) network communication suddenly stops and I start see
> error message like "eepro100: wait_for_cmd_done timeout!".
>
> I looked into this, and it appears that the SCBCmd byte in the command word
> has value 0x80 instead of the expected 0. I looked at the Intel manual, and
> it says nothing about the value being 0x80.
>
> Does anybody have a clue here? I suspect some timing is wrong or a buggy PCI
> controller.
>
> Please cc your reply to my email address. Thanks.
>
> Jun
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
>
--
Christophe Barbé
Software Engineer
Lineo High Availability Group
42-46, rue Médéric
92110 Clichy - France
phone (33).1.41.40.02.12
fax (33).1.41.40.02.01
www.lineo.com
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:17    [W:2.495 / U:0.088 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site