lkml.org 
[lkml]   [2001]   [Mar]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: UDMA 100 / PIIX4 question
Tim Moore wrote:

> quintaq@yahoo.co.uk wrote:
> > I have an IBM DTLA 307030 (ATA 100 / UDMA 5) on an 815e board (Asus CUSL2), which has a PIIX4 controller.
> > ...
> > My problem is that (according to hdparm -t), I never get a better transfer rate than approximately 15.8 Mb/sec. I achieve this when DMA is enabled, - without it I fall back to about 5 Mb /sec. No amount of fiddling with other hdparm settings makes any difference.
> > ...
>
> 15MB/s for hdparm is about right.

You should be able to get about 30 MB/s at the start of the disk (zone 0) according to IBM's datasheet at

http://ssdweb01.storage.ibm.com/techsup/hddtech/prodspec/dtla_spw.pdf

so if you were testing say /dev/hda1 which is at the start of the disk it should be faster.

Try hdparm -i /dev/hda (or whatever) .. . note the reported MaxMultSect= value,
and put it in place of X in command:

hdparm -u 1 -d 1 -m X -c 1 /dev/hda

Cheers,

Jeremy

PS - please let me know if this fixed your problem, since I have a system
with the same motherboard.

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:29    [W:0.364 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site