Messages in this thread |  | | | Date | Thu, 18 Jan 2001 08:43:40 +0100 | | From | Petr Matula <> | | Subject | Re: int. assignment on SMP + ServerWorks chipset |
| |
On Wed, Jan 17, 2001 at 01:33:42PM -0800, Linus Torvalds wrote: > Did you also remove the two lines that disabled pirq routing if an IO-APIC > was enabled? Yesterday not, today yes. But it's the same.
> > Kernel with these changes can't detect my SCSI drive. It prints these messages > > in cycle: > > Which SCSI adapter is this? It may be that you have one of the drivers > that does not do "pci_enable_dev()" at initialization time.. SCSI storage controller: Adaptec 7899P (rev 0). IRQ 16. Master Capable. Latency=72. Min Gnt=40.Max Lat=25. I/O at 0x5800 [0x58ff]. Non-prefetchable 64 bit memory at 0xfd000000 [0xfd000fff]. Used kernel options: CONFIG_SCSI=y CONFIG_BLK_DEV_SD=y CONFIG_SD_EXTRA_DEVS=40 CONFIG_SCSI_DEBUG_QUEUES=y CONFIG_SCSI_CONSTANTS=y CONFIG_SCSI_AIC7XXX=y CONFIG_AIC7XXX_CMDS_PER_DEVICE=8 CONFIG_AIC7XXX_RESET_DELAY=10
Petr
--------------------------------------------------------------- Petr Matula pem@fi.muni.cz http://www.fi.muni.cz/~pem --------------------------------------------------------------- - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/
|  |