[lkml]   [2000]   [Feb]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: eepro100 not working properly
    Jens Axboe wrote:
    > eepro100 does not work well after the 2.3.45 changes. It works after
    > a cold boot, but after a warm reboot no go. The device is detected
    > and eth0 brought up, but I get no response from the other end.

    Can you check and see if this behavior exists in 2.3.45-pre2 also?

    I enabled Becker's ACPI logic in 2.3.45 eepro100, and that sounds like
    it may be the culprit.

    Jeff Garzik | Writing software is
    Building 1024 | more fun than working.
    MandrakeSoft, Inc. | -Anon

    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    Please read the FAQ at

     \ /
      Last update: 2005-03-22 13:56    [W:0.021 / U:63.376 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site