Messages in this thread | | | Date | Mon, 30 Oct 2000 19:55:40 +0100 (CET) | From | Pierre Etchemaite <> | Subject | Re: ide/disk perf? |
| |
Le 30-Oct-2000, Mohammad Haque écrivait : > At the bottom is the IDE/ATA part of my .config. let me knwo if I am > missing something. Should I worry about the Multi_Mode configuration?
I have it enabled, however I never used any HPT366 controller, so YMMV. The BX chipset is what I tested the most.
># ATA/IDE/MFM/RLL support ># > CONFIG_IDE=y > CONFIG_BLK_DEV_IDE=y > CONFIG_BLK_DEV_IDEDISK=y ># CONFIG_IDEDISK_MULTI_MODE is not set > CONFIG_BLK_DEV_IDECD=y > CONFIG_BLK_DEV_IDESCSI=m > CONFIG_BLK_DEV_IDEPCI=y > CONFIG_IDEPCI_SHARE_IRQ=y > CONFIG_BLK_DEV_IDEDMA_PCI=y > CONFIG_BLK_DEV_OFFBOARD=y > CONFIG_IDEDMA_PCI_AUTO=y > CONFIG_BLK_DEV_IDEDMA=y > CONFIG_BLK_DEV_HPT366=y > CONFIG_BLK_DEV_PIIX=y > CONFIG_PIIX_TUNING=y > CONFIG_IDEDMA_AUTO=y > CONFIG_BLK_DEV_IDE_MODES=y
Looks very similar to my own settings
CONFIG_IDE=y CONFIG_BLK_DEV_IDE=y CONFIG_BLK_DEV_IDEDISK=y CONFIG_IDEDISK_MULTI_MODE=y CONFIG_BLK_DEV_IDECD=y CONFIG_BLK_DEV_IDEPCI=y CONFIG_IDEPCI_SHARE_IRQ=y CONFIG_BLK_DEV_IDEDMA_PCI=y CONFIG_IDEDMA_PCI_AUTO=y CONFIG_BLK_DEV_IDEDMA=y CONFIG_BLK_DEV_PIIX=y CONFIG_PIIX_TUNING=y CONFIG_IDEDMA_AUTO=y CONFIG_BLK_DEV_IDE_MODES=y
But I only do
hdparm -qu1c1k1 idedevice
at boot time. Also, I've found
append="ide0=autotune ide1=autotune"
in my lilo.conf, left from earlier testing session. Remarks in ide.c say it only has influence on PIO modes, so unless the comment is obsolete I guess I could as well remove that line.
Best regards, Pierre.
-- Linux blade.workgroup 2.4.0-test10 #1 Mon Oct 30 15:30:15 CET 2000 i686 unknown 7:55pm up 4:12, 5 users, load average: 1.11, 1.20, 1.38
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/
| |