lkml.org 
[lkml]   [1999]   [Sep]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Getting ISDN Card working (was vendor ID in /proc/pci)
In article <802567FA.004ED16F.00@genesis.tele2.net.uk> you write:

> I'm not sure if this is the place to raise this issue about
>configuring the ISDN card but I'll try anyway or if some could point me in
>the right direction. Thanks to all those who helped me I finally found out

The right mailing list would be isdn4linux@lists.isdn4linux.de (cc'ed in
this message).

>my card was a Datalink but that is as far as I managed to get. I managed to
>lay my hands on some drivers for the dynalink card built against 2.2.12. I
>tried to load these using modprobe hisax but this just comes pack with
>
>/lib/modules/2.2.12/misc/isdn.o: init_module: Device or resource busy
>isdn: No such file or directory
>
>however dmesg shows
>
>ISDN subsystem Rev: 1.86/1.72/1.88/1.49/1.16/1.2
[...]
>HiSax: Card 1 Protocol 1TR6 Id=HiSAX (0)
>HiSax: Support for ISDNLink Card not selected

This means that the hisax module was not configured for the ISDNLink
card (this is configured when configuring the kernel). I.e. the config
needs to be changed, and the module recompiled.

Also, I see it says "Protocol 1TR6", which I believe is not what you
want for the UK (or in fact almost anywhere). Pass the "protocol=2"
parameter.

Paul Slootman
--
home: paul@wurtel.demon.nl http://www.wurtel.demon.nl/
work: paul@murphy.nl http://www.murphy.nl/
debian: paul@debian.org http://www.debian.org/
isdn4linux: paul@isdn4linux.de http://www.isdn4linux.de/

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:54    [W:0.037 / U:0.564 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site