Messages in this thread | | | From | "Ashish Lal" <> | Subject | configuring IP | Date | Fri, 19 Nov 1999 10:12:09 -0500 |
| |
I have installed Linux 2.2.9 (with an ATM patch 0.59) on a Dell 450 MHz Pentium. I have 2 ATM interfaces (and 1 ethernet interface). Both ATM interfaces have been configured to work with IP and are doing fine. I want to configure the IP stack in Linux so that when I ping from 1 atm interface (atm0) to the other atm interface (atm1), the ICMP packet actually goes out of interface 1 (atm0). Though the ping responds correctly, I find that no ICMP packet has actually gone out of the interface (which I can verify from an analyzer). Is there an easy was to configure IP, may be by using some compile time flag that I can actually see the ICMP packet go out of the interface? I am trying to look into /usr/src/linux/ipv4/icmp.c and /usr/src/linux/ipv4/route.c. I would like not just ICMP but any IP datagram actually going out of interface 1 when it is sent via IP to interface 2 on the same host Thank you and warm regards. --Ashish
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |