lkml.org 
[lkml]   [1999]   [Nov]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: Need info about serial port programming -UPDATE
Date
From
Theodore Y. Ts'o wrote:
> Even if you're onlysampling at a rate of ~500 Hz or so, you probably
> want to do this using RT Linux, using a kernel module, and hitting the

The question is wether he needs the RT aspects. I had understood that
he can CLOCK(*) the device. So as long as he's doing the toggeling at the
right average speed, everything is fine.


Roger.

(*) many clocks are equidistant. Many don't need to be as long as you
adhere to the "min low time" and the "min high time".

--
** R.E.Wolff@BitWizard.nl ** http://www.BitWizard.nl/ ** +31-15-2137555 **
*-- BitWizard writes Linux device drivers for any device you may have! --*
"I didn't say it was your fault. I said I was going to blame it on you."

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:55    [W:0.071 / U:1.204 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site