lkml.org 
[lkml]   [1998]   [Jun]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: BTTV w/ no sound?
    On Wed, 10 Jun 1998, Gerd Knorr wrote:

    > On Tue, 9 Jun 1998, Erik Andersen wrote:
    >
    > > > Do you have an MSCP3400 on your board ?
    > >
    > > I am not sure. How would I check? (A few minutes later after turning off my
    > > computer, and pulling the card).
    > >
    > > Ok, my card has a magic silver box with the label:
    > > WinCast/TV
    > > NTSC
    > > 60171 Rev C 1V
    > >
    > > In addition, it has the following two chips on it:
    > > BT ITT
    > > B848KPF MSP3430G-PS-A1
    > ^^^^^^^^
    > New chip version.
    >
    > > msp3400: I/O error, trying reset (write Demod 0x1)
    >
    > Might be a problem with the i2c bus. If "insmod i2c scan=1" finds around
    > three chips (probably at addresses 0x80, 0xa0 and 0xc2), everything is
    > fine. If not, mapping the bttv memory (with remap= insmod option) to
    > another place might help.
    >
    > Or the new chip is'nt (full) backward compatible to the msp34[01]0
    > versions.
    >
    > Gerd
    >
    >

    Ok, Lets assume that this is the case -- that this chip behaves differently
    then the earlier revs. Any pointers on where I need to go to find docs for
    this thing? It couldn't be _too_ different...

    -Erik

    --
    Erik B. Andersen Web: http://www.inconnect.com/~andersen/
    email: andersee@debian.org
    --This message was written using 73% post-consumer electrons--



    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.rutgers.edu

    \
     
     \ /
      Last update: 2005-03-22 13:43    [W:0.026 / U:0.012 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site