lkml.org 
[lkml]   [1998]   [May]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    From
    Date
    SubjectRe: Serial port overruns in 2.1.9x?
    > I also get the 'TCPv4 bad checksum' messages, and my PPP throughput is
    > also dramatically lower in 2.1.9x than with 2.0.33 or 2.1.89 (FTP
    > transfers at around 1.4K/sec vs. 3.2K/sec over a 28.8 modem).
    >
    > I've also noticed, however, that when using rz and sz to send files
    > to/from my shell account, I get massive CRC errors with 2.1.9x, which I
    > don't get if I reboot with 2.0.33... which would seem to indicate that
    > there are serial port overruns going on with 2.1.9x which aren't there in
    > 2.0.33.

    Hi,

    Result of "cat /proc/tty/serial/drivers" after the PPP ?
    Enable interrupt on IDE access "hdparm -s /dev/xxx"
    (re-check with man hdparm) ?
    CRC error : did you upgrade netcfg ?

    Just my Euro 0.02,
    Etienne.
    ----------- etienne.lorrain@ibm.net
    -- hdc: irq timeout: status=0xd0 { Busy }
    -- ide1: reset: success
    ----------> I like Linux !

    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.rutgers.edu

    \
     
     \ /
      Last update: 2005-03-22 13:42    [W:0.022 / U:94.416 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site