Messages in this thread |  | | | Date | Sat, 9 Aug 1997 08:32:50 -0400 (EDT) | | From | Dave Wreski <> | | Subject | Re: New pre-2.0.31 patches.. |
| |
> How do you have your termination configured? Make sure you have the > upper part of the wide SCSI bus terminated when mixing wide and > narrow.
Ok guys, I've checked termination. There was a problem with termination on my CDROM, but I've corrected that, and even disconnected it, and still having the same problem. Possibly it is a problem with the driver?
What changed in this version, from the stock 2.0.30 version, that could have made this difference?
What else can I try to fix this? I've enabled termination on each of the two internal drives, and tried both 'automatic' and low-off/high-on termination on the controller.
I've set the controller back to defaults, and checked each parameter on each of the drives for something I've missed.
Any ideas? Dave Wreski
> >Hi all. I'm having problems with the aic7xxx code in this patch. I'm > >assuming there isn't much/any difference between the July27 aic7xxx code, > >and Linus' pre-3 patch. > > > >The code is having problems with an older drive I have on my 2940UW: > > > >scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 4.1/3.2 > >scsi : 1 host. > >scsi0: Scanning channel A for devices. > >scsi0 channel 0 : resetting for second half of retries. > >SCSI bus is being reset for host 0 channel 0. > >(scsi0:-1:0) Reset device, active_scb 0 > >scsi0: Resetting current channel A > >scsi0: Channel reset, sequencer restarted > > > >It never finds my Micropolis drive. Its a pretty old drive, and is > >attached to the scsi-2 connector on the drive. There is a Seagate on the > >wide-scsi connector. There are no external drives. Information from > >booting stock 2.0.30: > > > >Host: scsi0 Channel: 00 Id: 00 Lun: 00 > > Vendor: MICROP Model: 4110-09NB_Nov18b Rev: TN0F > > Type: Direct-Access ANSI SCSI revision: 02 > > > >I've tried tagged queuing and page enable both enabled and disabled, with > >same results. commands per lun was set to 8, and relay delay was left at > >15. > > > >I actually thought the July27 code worked. If there is a difference, I > >can round up that code again, and try that if necessary. Anything else I > >can do? > > > >Thanks, > >Dave Wreski >
|  |