![]() | |||||||||||||
Messages in this thread |
During installation of a software router with three 100 mbit adapters, we got some problems. We are getting the following error: eth0: Too much work at interrupt, csr5=0xfc668000. Each time the message appears, the transfer seem to halt for a short time. The adapter is based on digital 21140-AC. We got a single card based on digital 21140-AB that works without any problems. We use kernel 2.0.27. We tried to use tulip.c from 2.1.20 but it does not fix the problem. Baldur | ||||||||||||
| Last update: 2005-03-22 12:38 [W:0.217 / U:0.000 seconds] ©2003-2008 Jasper Spaans | |||||||||||||