lkml.org 
[lkml]   [1997]   [Jan]   [12]   [last100]   RSS Feed
Views: [more markup]  [less markup]  [headers]  [forward] 
 
Messages in this thread
/
From"Magnus Hiie" <>
DateMon, 13 Jan 1997 00:36:43 +0200
SubjectRe: AHA2940UW UltraSCSI option
On 12 Jan 97 at 17:07, Sudish Joseph wrote:

> Joachim Achtzehnter writes:
> 
> > You need to enable UltraSCSI speeds in the board setup (you get
> > there by pressing certain keys during boot). Then the Linux
> > aic7xxx driver automatically enables UltraSCSI support. You can
> > verify this by looking at the file /proc/scsi/aic7xxx/0.
> 
> Adding aic7xxx=ultra to lilo's append= options gets me
> 
> scsi0: Target 0, channel A, now synchronous at 20.0MHz, offset 15.
>   Vendor: SEAGATE   Model: ST32155N          Rev: 0318
>   Type:   Direct-Access                      ANSI SCSI revision: 02 
> 
> Better than being synch at 10.0MHz. :)  This is with an AHA2940U. 
> The option isn't documented, I think, but is present in the options
> struct in aic7xxx.c.
> 

I didn't notice the startup message. Yes, it really runs at Ultra
when enabled at BIOS setup. Thanx and sorry. 

*********************************
Magnus Hiie
Computer Manager
Eesti Ekspress
E-mail: mgn@ekspress.ee
Tel: +372 6408046
GSM: +372 50 57507
\
 
 \ /
  Last update: 2005-03-22 12:38    [from the cache]
©2003-2008