[lkml]   [1996]   [Jun]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    Subject3c59x (v0.25) problems with 1.99.11

    I upgraded to 1.99.10, and had a lot of "UDP Checksum errors" and "socket
    destroy delayed". I thought I should do my most to stop it, so when I
    upgraded to 1.99.11, I changed 3c59x.c to the 0.25 version I got from the
    Vortex page (the author of the driver I think).

    Well, I got rid of the above problems, but now instead, three times in 40
    hrs, my ethernet stopped working. As far as I can see from my transciever
    leds, there is traffic, but Linux doesnt see it. Tcpdump shows nothing,
    etc. I do a

    ifconfig eth0 down

    and then reconfigure the eth0 device, and it works again. No reloading of
    the 3c59x module or anything, I just ifconfig eth0 down and then up again
    and add the routes.

    Anyone else experiencing these problems?

    I have compiled 1.99.12 now, and I plan to reboot later this evening.

    eth0: 3Com 3c590 Vortex 10Mbps at 0xff80, 00:a0:24:77:27:24, IRQ 10
    8K byte-wide RAM 1:1 Rx:Tx split, autoselect/10base2 interface.

     \ /
      Last update: 2005-03-22 13:37    [W:0.018 / U:17.876 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site